- Thunder Shootout(new Top Dog)
- tranny line question
- Sway Bars
- Tunning needed with Z06 cam
- Turbo kit for trucks??
- Cam for a new 5.3 and a Radix?
- where to get desensitizer for knock sensors
- need to know how
- best tires(traction) without heating?
- Dyno Results
- Header install .. now misfire codes are thrown
- Ideal A/F for na motor?
- Dual exhaust questions?
- Fuel Injectors
- how many mileson this motor? did i get riped? pic's
- Whipple and TEC
- Top engine cleaner
- Cam suggestions for 6.0(lq4) and Whipple??
- k&n oil filter #
- Anyone here with LaPole headers???
- Finally some new times and cold weather
- Everybody come in!-I raced a single-cab 5.3, have some technical ?s
- some 4wd 4l80e swap info
- Anyone have problems with their rearview temp guage?
- ZO6 cam gains
- Tranny cooler arrived
- Optima battery....
- 373locker rear end any good
- Which supercharger would be easiest to dyno-tune w/ my set-up?
- bigger throttle body worth anything?
- ok i had enough i am done!!
- F/S NX Wet Kit
- how to reduce pcv oil consumption
- Plug wires
- Coated TOG's
- 1/8mile,me vs a hemi
- how about this build
- Which plug wires with ASM's (MSD sux)
- 6.0L SS cam?
- antenna sway
- SEMA 2003 Photos - Many Trucks!
- Can you dyno a AWD truck
- anyone know of nitrous fill shop in Dallas TX?
- Taylor Plug Wires are in!
- Need cam specs!!!!!!!
- f-body cam in 5.3L
- Where is the outside temp sensor located?
- Just bought a 4L80E for the Tahoe
- Installed Transgo and servo have Questions??
- LS6 cam in 5.3L
- More cam questions ..
- swapping 5.3 to 6.0, CARB legal??
- Heated outside mirrors
- about compression ratio & milling heads
- pic of tripple gauge pod and wideband gauge
- would this cam be too much
- Need some cam insight.....
- Need some help, truck making odd noise
- LOOK what I just bought
- Calling ATI procharger guys
- What mods should I do
- Lightning vs. Silverado
- Long tube headers for 5.3L
- LS1Edit for 03 trucks
- exhaust for 5.3 03 sierra
- moding a 6.0 liter
- Clunking noise from base of steering column
- 5.3 to a 383 stroker????
- Tranny Coolers
- Test Drove 2003 SS
- G-Tech Pro?
- 5.3 with a Magna-charger
- Track Times?
- Another question about my Predator! Tow/Haul mode?
- ¿Resetting "Change Oil" light?
- Where are you guys getting your MSD wires
- Is My truck a lemon? What problems have you had?
- PCM pin configuration
- G80 problems
- 4.8 heads on a LQ4
- Long or short oil filter, what do you use?
- Chirping or squeeking noise from the belt
- Underdrive pulleys???????
- What head gasket should I use?
- Predator Impressions
- Interested in some free magnaflow exhaust?
- transgo advise
- Ported and polished 5.3L heads
- Fuel Injector vs HP Conversion
- engine swap
- tranny question
- SES light after tb bypass?
- Is this a good Nitrous express kit? (QUICK)
- gtech times and track
- Water wetter?
- MSD wires, underdrive pulleys?
- LS1 Edit help?
- Trail Blazer torque converter and tranny questions (long)
- Truck is going on Dyno again this Sat.
- in depth ?s about converters and gears
- Should I try a Predator custom tune?
- Does the UPD really work?
- torque management
- Made a few runs, at the track for first time
- New times
- engine mod questions?
- splug wires, need to change
- Track times with the 6.0
- price for eaton install
- 4L60E trouble
- 4WD switch
- Supercharged Reg Cab SS Truck
- Intercooled Whipple Kit???
- Tranny Probs
- looking for decent a/f guage - gadgetseller?
- How to beef up my 5.3
- Will these make a good combo
- Will these make a good combo
- Question for those with 4.10 gears
- 160 thermostat
- flowmaster muffler or system for 03 HD
- Whipple Performance
- Anyone have over a 224 cam in a 5.3
- where to get edit tuning
- Underdrive pulleys
- best spark plug wires
- spin on a roll
- Edit tuned the truck today! Long.
- ati dyno results
- First time 1/4 mile times
- Mods to the UPD
- I think I found our why ......
- good tranny shop in pasadena tx
- This truck blew out a plug!
- New Gtech times after tuning
- OBS L31: Swapped stock catback back on (comments)
- Catback Q
- home made air intakes.
- ls6 cam
- Is it possible to bore a 5.3 to a 5.7?
- is it that whacked to stick a t56 into a 00 rc 4.8?
- sparkplugs?
- nitrous GOD? not me, boom/fire!!!!!!
- 5.3 RCSB Times
- 2500 hd ran pretty good.
- Problems with tranny fluid and filter swap
- 2004 Exhaust question
- Just got a Predator
- Cam questions for 5.3L
- Swapping truck fuel rails to camaro fuel rails?
- New Silverado SS questions
- Cam for an 02 Denali XL
- best programmer for duramax?
- Fuel injectors revisited
- westers
- ignition question
- PO300 code misfire/detected
- kenne bell??
- 6.0 heads question
- What's the deal?
- New 04 2500HD ????
- Voltage fluctuation-alternator going?
- Intake gaskets
- changing whipple pulley?
- life of engine with nos
- OK,need the Ls1styleTech guys help
- spark plugs
- Nitrous Jet thread
- O2 Sensors
- 98-02 Camaro Electric Fans on 03 Silverado
- Attn: Peeps with new body 4 door Tahoes...re brakes
- fuel pressure question
- Power gains with headers?
- what the hell is my problem?
- Looking for Muffler Recommendations
- does anyone remember?
- just rolled 176,000miles yesturday
- LS1 edit or westers
- help with atap
- Aftermarket Performance
- anyone know stock cam grind?
- brake pads/stainless lines
- Bosch +4s any good?
- Thinking of adding a custom made ram air...
- Newbie to the trucks, what are the basic mods?
- 75K on 5.3 and 4l60E got a ?
- Turbo
- How will this cam do in my truck.
- Crank pulley is kicking my ass
- New Regulator in town
- Anyone in here do P&P work on heads?
- 410 or 373 what would be best?
- Understanding LSA...
- belt slipping
- When I steer it makes a clicking sound
- 234 228 cam
- Glove Special!
- Magnacharger Radix SALE!!!!
- 4.3 to 5.3 swap
- What is needed for a 6.0 to handle boost?
- K&N vs Amsoil comparison
- Let the carnage begin
- Need a smaller pulley for your Radix?
- UPD/Nitrous Nozzle?
- 5.3 parts
- Has anyone stroked the 6.0 via Lunati?
- Spark plugs, again...
- Meziere pumps, Predator programmers and all headers on sale!
- Any info out there on a LS1 in Trailblazer
- Need pics/info re: 4.8/5 speed trucks
- Noisy starter....Shim it????
- Motor Madness
- will the cam out of My SS fit in my 4.8p/u?
- TOW RIG gets a new best!
- 4WD Trucks In Here
- shorty headers??
- ecm tune
- Stock header bolts hard to remove?
- Volant Induction System
- What are your shift point set at ?
- Magnaflow exhaust questions
- Knock Knock
- Time for a new Project........
- torque management
- cam sound clips
- Putting JBA shorties on my truck?
- Arp head bolts or studs? and injector question.
- Fastest 4.8L???
- 5.7 vortech help!
- Just had my richmond 3.90 gears installed this morning
- New best 1/8th mile time!
- Any experience with Thorley 310Y Tri-Y Headers?
- Got SS 3800 today!!!
- 4.8 loves nitrous
- New best et and a problem
- brake pad?
- Procharger guys-new intake from ATI!
- exhaust question
- serpentine belt
- Well the Dyno Numbers are in
- Question about Rebuilt Chevy Tranny
- Smoothing out timing curve?
- Corsa exhaust fit - does yours do this?
- Racing my truck tonight - need your opinions
- Anyone ever heard of.....
- Cam question?
- need tuning for a 99 truck with a whipple
- Supermaxx Headers
- Guys with 6.0(lq4) and Whipple..what size pulley u running??
- whipple shift points?