- intake manifold question
- duel alternators
- Best Air Intake for a 00 Silverado
- 05 silverado 5.3L I want a 100 shot!
- Fan removed, not what
- Fuel Pressure gauge install help...
- is the 4.8L a good turbo motor-
- Just installed 42lb injectors and Nelson PCM
- Engine Comparison?
- Has anyone?
- hopefully an easy question..
- Swap to a LS6 Intake need help
- Where to buy a bolt strech gauge
- LS1 Silverado Swap... HELP! ???
- Quick question?
- best upgrades?
- which head gaskets?
- Quick Question
- Tb Spacer?
- When to switch to synthetic oils???
- Easiest way to remove water pump?
- another cam question sorry folks
- pacesetter ory
- Anyone built their own headers?
- Stainless Work Headers
- ok my turn for exhaust.
- Have misfire problem
- Engine runs rough when cold - Why?
- Will this MAF work?
- No muffler?
- Magnuson Supercharger/Dynatech Long Tube Headers Special!
- upgraded injectors are in...but...
- Switching from Flow-40's to Magnaflow..
- Quick ? about Pacesetters and the ORY
- How good is the ARMOR Coat on PS Headers??
- starting 6.0 install tomarow
- K&N fit years??
- im getting boosted!!
- Ultimate 5.3 setup
- Who has changed just the muffler?
- Vortec Max performance question
- where does everyone get their aerochambers?
- Any dyno comparisons between the truck intake and the LS6 intake?
- 5.3 pullies?
- Crazy 02 sensor...
- How will these work?
- Vortec 6.0 to LS2 conversion.
- i need a coil pack!!
- Another cam question? about pushrods
- stirring the intake pot
- stainless works headers for 2500HD 6.0
- strange noise
- rcsb 5sp z71 w/6.0?
- Cam advice
- Exhausting black smoke.
- GM Truck Perf. Questions
- Intake poll
- 4.8=13s?
- Injectors for a 96 silverado???
- Opinions needed...catalytic converter stuff
- Lq4 v. Lq9 pistons
- Edelbrock Victor Jr.......I think its the best choice for us truckies
- f/y-body intakes on a truck?
- Think I broke my crank what to do now?
- crank pulley from LS1
- cam and nitrous setup?
- 6.0 In But Wont Run (Backfires)
- Laptop Tuning
- Noise Fram Boost vs AEM
- Injector questions
- cam replacement
- 02 chevy tahoe problem need help asap
- cam questions
- is this new 6spd a bolt on replacement for the 4L6X-E?
- not your typical cam question
- Thinking of a engine swap, but which one?
- 04 5.3 needs alittle power for alittle money
- Intake
- Need Long Tube Help asap.....Questions
- LT with no cats!
- Got all my parts
- Lq9 + headers + tune = ???4L65E???
- Getting Pacesetter LT's... ORY or Duals?
- obs 5.7 long tubes
- 05 Tahoe that won't get out of it's own way..
- E Fans and DCControl Opinions?
- Good price???
- Exhaust help, stock 1996 5.7L tahoe
- New thoughts on my exhaust
- any body have sound clips oof a bullet to a magnaflow
- weight of 6.0??
- 1997 L31 Vortec 350 marine intake fueling issue
- Flo-Pro Purchase???
- Shorty Header Question
- 5.3L into a 98 Tahoe?
- fuel pressure regulator location
- dynomax bullet
- Anyone done a conversion from truck manifold to LS6 or FAST Manifold?
- time to start on my new tahoe.
- Newbie Cam Help
- Looking for Inline Pump install thread
- My truck with Corsa SIDE exit PICS!!!
- piston help
- SSS Magnaflow Dual Catback Mod ??
- LQ9 with 5.3 P&P heads??
- Critique this 5.3 setup
- pace setter headers???'s
- Help my 98 obs out!
- Does Anyone Know Of Any Kind Of Online Exhaust Calculator??
- high impedence vs low impedence injectors
- injector question 5.3 to 6.0
- Corsa modded to exit in front of rear tire....
- new or used heads
- ...][ Quesitions About Headers, Cams, and some other things ][...
- cam swap
- pacesetter 4wd headers
- Stepped band clamps won't fit pacesetter ORY B/C O2 bungs are too close? T or F?
- 2005 Suburban 5.3 Fusebox label
- I bought a cam
- playtime has commenced......
- ls1 cat for a s10
- 160* thermostat
- Info on Cast # 241 heads???
- What order?
- Doing heads but no cam??
- dont drive too low.
- Vic Jr fuel plumbing parts list
- Quick Question.. Do I NEED a timing chain for a cam install???
- 2000 Yukon Question
- LS6 Heads
- 2 speed fan
- 02's ?
- ***HUGE Labor Day Sale Going On Now!!!***
- would these be a direct swap?
- suggestions for heads
- New Truck :(
- Drilling TB
- Running lean
- 24lb injectors
- Quick vid of my new exhaust
- 98 chevy 5.7L headers
- Which oil weight?
- 6.0 heads on a 4.8?
- how much loss of low end power
- Fastest bolt-on truck?
- gutting cats???
- Engine pics, painted intake
- Throttle Bodies
- How would the most average power be made?
- 5.3L s-10 Swap Dyno's 448RWHP 456RWTQ
- Hook up at local exhaust shop
- what brand pushrods?
- LS1 Fans.
- LS1 cam in an 03 5.3 Z71. WTF??
- Please Help! Guys with FAL fans and nelson fan harness
- New 2006 4.8
- Who is running a 02 LS6 cam in there truck?
- Corsa sport muffler question....
- Could sombody help
- Borla XR1
- Those with cams in Cali?
- Cam help.
- Has anyone use the Stainless Works CATBACK?????
- help 4.3 to 6.0???
- spark plugs
- got my headers
- What rpm stall are you guys running?
- 2006 8.1 injectors direct replacment for 01's?
- HELP!! Electric fan problems.
- 6.0 questions?
- Does anyone have dyno info near 2000rpm for pacesetter LTs compared to stock?
- Squeaking motor--sounds like idler pulley maybe
- should i buy
- why dont 5.3 asp pullies fit the 5.7 LS1?
- flowmaster catback
- The Other Guy headers still around?
- difficulty of twin turbo setup on '94 350?
- Aftermarket fuel rails and fp regulator
- Return style fuel system to returnless
- Are there any Street Legal LT Headers?
- o2 question
- 6.0 block
- DBW90mm/Carb Adapter
- Long tube headers
- Engine builders in SoCal?
- Looking for a set of heads for 4.8
- Speed Engineering's Current Online Sales!!!
- LS1 e-fans = Silverado e-fans
- Rocker Arm ?
- Project questions
- The right cam install gasket kit?
- comp cam xer 6.0
- 5.3 or 5.7 Next?
- Edelbrock Victor Jr installed on H2
- LT's on now what?
- got a ? on pushrods
- Thinking about a LQ4
- Ls1 Intake swap and keep your truck accessories
- what causes plug fouling?
- gaskets
- stock 02 silverado ready for mods
- Best way to 12's?
- o2 sensor and LT's
- need advice !!!
- 5.3l cam help...
- Corsa muffler only
- New car problems
- LS1 Intake Swap
- Advice on this noise?
- O sims for 06 4x4
- which lt's 06 4.8 in CALI
- spintech rant
- my mods
- For all you Overheating guys....
- S&B inatke
- Who is running 60lb injectors??
- Needs torque.
- new exhaust setup
- who has done a helicoil on Al. heads?
- doin the 6.0 this weekend
- 4.8 power ???
- Tapping, fadding in and out...
- Gutted Cats w/ Magnaflow dumped now what?
- pinging?
- Pacesetters w/stock cats?? ANyone?
- small duration large lift truck cam ideas
- rich? not sure where to put this
- Stock LQ9 6.0L Oil Pressure at Idle?
- Programmers
- ls2 injectors
- Pacesetter LT's from JBA Shorty's
- Carbed Lsx Motor
- Pacesetter 4X4 LT's
- 05 + voltage spikes = low fuel pressure
- Overheating at Idle
- Ngk Tr6???
- Upgrade over factory injectors, what ones?
- Help! Overheating....
- What IF?
- helicoil, how to?
- Which Lt tubes are best?
- 1996 1500 truck Starter removal?
- Can a stock 5.3L hold 600whp?
- escalade engine covers
- Can someone explain how the VVT works on the 2.9/3.7/4.2 engines
- Who makes the best ignition wires?
- LS1 Intake Swap (Already Used Search)
- How does the 8100 like e-fans?
- serious problem need help now
- TBYRNE Motorsports Sales Ending 8/20