- 245/50/R16 dr diameter?
- What about these cam spec's for my 6.0
- 5.3 vs 5.7 block
- ? for 69SS509
- Silverado SS has a clutch fan?
- Considering a Silverado SS - What's available?
- Thought all 6.0 heads were the same.....
- How much power is freed up with these mods?
- TOG header question
- Benifits of going dual
- Can someone help? Edit Question
- rev limiter?
- true duals & x pipe
- Just bought a 454 ss truck! Got a few ?? about performance
- 6.0?'s
- purging into area behind grille...
- Question on changing oil pump
- Need help with Plastigage and rod bearings!!
- Money To Spend, What Next? Help Guys!
- AutoTap...Which one??
- Any ideas/suggestions on what broke...
- dyno numbers are in
- Dynatech stands behind their product
- rim question?
- 4L60E Question??????
- Open Headers and no rear O2 Sensors...
- A/C Belt Removal
- Cats are gone!
- radix on an 01 denali....will tranny hold ??
- Intercooled Whipple
- Radix Provisions?
- Almost everything on sale! Save up to $200. by ordering online!
- Patriot Performance Stage II 5.3L Cylinder Heads
- Beating a dead horse TB Port & Polish How to:
- What can you tell me about failing the inspection due to HC's ?
- Has Anybody Tried Rocker Arms?
- Need Motor Advice WHAT SIZE CLUTCH DO I HAVE?
- trans and motor mount questions.
- Confused after new cam install
- Tuning.
- what gear to put in?
- throttle body?
- Granatelli or Z06 MAS and/or BBK 80mm Throttle Body?
- 4l80e shift kit is in
- VR Velocity Stack
- Projected Dyno #'s??
- 6.0L question
- Engine is in!!!!!!!!!!!!!!!!!
- Bolt on mods
- Knockout Box Users
- ATI P1sc-D1sc swap??
- 3.73 vs 4.10
- 300 miles after Pro Cold intake installation.
- nitrous is installed, but...
- Anyone know if ASP pulleys
- Power Steering Pump?
- 4.56 gears-anyone tried them
- More 8.1 info needed ...
- Airbox modifications
- Hypertech problem?????
- ProCharger questions....
- Last Minute Tips for ASM Install tues or weds
- New B&B TriFlo exhausts for the Silverado SS
- Vortech Vs. Powerdyne
- I want a fuel pressure gauge
- Gear question?
- Pulled oil pan again,everything looks fine??
- Air Intake Sound Comparison
- Need some info on the TCI 4L60E Super Street Fighter Torque Converter
- What do you guys think of these S/C's
- Holy Sh*t the knock was loud this morning!!
- parish, got a few tranny questions for ya
- parish, got a few tranny questions for ya
- Upgraded aftermarket power steering pumps? See Pics
- Just wanted to wish everyone and their families...
- Anyone used a single in/out muffler with a Y-pipe for dual tailpipes?
- Hey BigTeX
- b&m shiftplus
- LQ9 versus 2002+ Z06 cam specs
- What should oil pressure be at 2000 rpm?
- magnaflow part#
- bar/cage questions? other track rules?
- anyone with race/curb weights
- G-tech comp
- The Edge Juice RULES!!
- Parish??Dyno??
- Help!!
- Eaton is in, haven't put the brakes on yet
- magnaflow 14"
- ASP Pulley
- Will this shift kit work on my truck
- New exhaust again...
- Paging Parish8
- CAMSHAFT for LM7????????HELP???????
- cottmans fix for the transmission :mad:
- free hp ideas
- big block s10
- Boost question
- Air Mangement
- shakes
- Eaton install is becoming a nightmare
- To much time on hands.......
- installing 6.0 in RCSB 1500 4x4 Z71
- Impressions of Vig3200 and other stuff...
- new best gtech with 150shot
- boost= how much hp
- Would this blower work on our engines
- I need exhaust.......
- Tbyrnes "Timing Tuner"
- Dyno results
- Radix Blower
- speedo change ?'s
- exhaust
- Tranny Problem?
- 15 PSI for Christmas!!
- Tahoe rear suspension on a truck
- Under Construction
- Getting ready for a Cali smog
- anybody experience this before?!
- Not passing smog test please help!!!!
- put bearings on the Eaton the hard way
- Installed Hooker Aerochamber muffler on L31/5.7 OBS Tahoe
- Predator Question
- Gibson Upgrade ! Much better
- $100. gift certificate give-away!
- B&B TriFlo exhausts - new systems + lower prices!
- '04 factory programming, issues w/mods?
- Preditor Tuning Info
- Headers
- ok dont know where this goes 97 Z71 Question
- remove thermostat for radiator flush
- Where to buy 4.10 & Eaton Posi
- Throttle body spacer?
- ASM Headers
- Before I put my engine in!!!1
- Leaving some tread on the ground...
- questions on 99 Z71 rear end gears/diff
- Cutting off exhaust tips
- Do you have a service manual?
- Scantool.net OBDII interface...at a REASONABLE price
- Heads for LM7 5.3!!???
- 6 Liter Intake
- Camshaft for '99 LM7 5.3L
- Cleaning O2 sensors?
- Paging Big Tex
- Converter
- Just got a new ride - Where should I start?
- UPD intake
- Ordered Smoked UPD
- O-ring on oil pick up not the problem
- Need converter info here
- Head swap question.
- looking for some supercharger answers
- Everyone who has put a LS1 in a truck, come in.
- just wanted to say..
- Engine swap ?'s
- Help w/ 4L80e
- Answer from Pro Cold about using the OEM intake tube.
- anyone have 1.3x edit?
- SS Silverado Cam Install
- radio noise w/ new plug wires
- new 60' times not so good w/ auto 4wd
- Need some help with LS1 Edit...BigTex, Parish?
- Good info inside!!!!
- injectors 101! please!
- fuel pump whine at startup???
- new TB i finished today.....
- hpp3 settings
- Y2K Silverado's Pro Cold Intake
- Y2K Silverado's Pro Cold Intake
- Y2K Silverado's Pro Cold Intake
- GRRRRR!! edit problems on 03 truck
- I am interested in opinions about a new performance truck.
- Pro Cold installed, pics need hosting!
- Predator Guys in here!
- O2 sensor and TPS sensor output wires?
- Got my reply from Whipple
- Need help with piston slap.....
- 5.3 trans killer
- Awd Upgrade
- pcm pin numer for fan control?
- 2004 Radix Kits Now in Stock!!!!
- What servo with transgo?
- n2o dry kit on 6.0
- Anyone with a 6.0 and shorties?
- SLP Loudmouth?
- battery or starter?
- "Old man" tranny setup?
- Vortech's supercharger with Aftercooler for the 4.8, 5.3 and 6.0!
- Cam Pos. Sensor
- 2004 Radix superchargers now available!
- Adding an OE trans cooler....
- Wet Nitrous Systems: What parts does someone need & other Questions
- trailer lights???
- Pictures of exhaust setups... under the truck?
- Looking for torque converters for 4l60E
- N20?'s
- z-71 gear question.
- Radix on a 5.3
- varaam stacks
- out of couriosity how hard is to swap a duromax into a 5.3 based vehicle?
- Injectors for 5.3, just splice wires or are there adapters?
- Whipple Supercharger problem...
- U-Joint Question
- MAF directly on TB
- Will 255's hook with a 3000 stall?
- anyone used NITTO 555DRs?
- The mighty 6.0 has fallen.
- Parish??
- thermostats
- some 4l80e info
- Valve train noise when engine cold??
- I'm the ginnea pig, order a Pro Cold intake.
- Well I did it!
- Radix Pulley and Boost Gauge Special
- HPP3 or LS1-Edit...
- New best time!!
- 255\50\16 --right size drag radial?
- MSD wires
- Transgo Shift Kit Install
- Finally hooked up at the track --- NEW TIMES!!!
- Need Advise. Looking to purchase used 2500HD with 6.0
- Eaton Install Tech Article
- Solid or hydrolic cams
- Drivetrain mod recommendations
- Plugs make a difference?
- what intake should i use for a 383 .....????
- Pcm For Less
- ProCold Intakes
- power loss w/s.c
- paging agreif- Eaton Q's
- NX back on.
- Superchips shifting
- SuperCharger Special!
- Just back from the dyno... Cam swap.
- Holiday supercharger sale
- New lift and performance mods for the HD!
- Pics of Cutouts, and Platinum Gauges
- are these the right sims?
- Radix HP Limit?
- Magnaflow and volant
- Tell me what you think about these mods
- Electric Fans??
- need more power
- portable units
- 2000 Silverado mods
- what about this set up
- Volant induction special
- Cam questions....
- installed cutouts today