- Another TransGo Questions.
- getting a little quicker
- Torque conv. bolt help!
- Cats
- Best mods for 04 2500HD 4X4 6.0 RC
- Pin outs for stock guage cluster?
- Please Help Me Go Faster!!!
- oil filter
- First passes this year !!!
- is the 4l60 in the f-body/vette the same that's found in the v8 trucks?
- Put the Edge Juice box on
- 2nd gear ratio?
- Detonation???
- narrowed to four cams.. which one?
- 2004 Tire Pressure sensor
- 2001 Tahoe as a Tow Vehicle
- would it be cheaper to build my own 6.0L?
- getting harder to start....
- STS Turbo repalces the Muffler?
- wiring harness question
- STS Turbo vs. Modified Whipple???
- Goodguys Nats
- Its going to be nitrous.
- Transmission Question
- Vegas Anyone
- whats better
- Putting snap ring back on servo cover
- New magnaflow muffler installed
- In What Order Advice For Next Mod(s)
- noob questions
- FYI, Velvet ride shackles
- Mild Setup - Opinions
- wiring harness for 4.3 to 5.3 swap
- 80e help quick please!
- new times
- How would you spend 3k?
- Masss Air Flow
- Which cam for my LS1 set-up...220/220 or 224/224?
- Mileage decrease in Yukon after FIPK?
- N20 with 4.10's and Transgo--PLEASE HELP!!!!
- looking for pics of powerdyne installes
- Ati ?
- Who has had the biggest improvement over stock?
- 6.0 Exhaust
- 2500HD CC 6.0L whipplecharged, which converter?
- Went to the track with the crate motor/4l80e
- finally a sound clip and small vid--cam.
- 03 throttle body 4.8?'S
- explain cooling lines, heater/overflow to motor
- Comp 915s vs 918s
- Whipple supercharger question
- For all of you CAM people . . .
- Allright, help me with my driving clunk...
- Torque Converter ?
- steering box question...
- 4wsteer silverado
- Tranny cooler?
- 1999 6.0 Injectors
- SES Help
- 6.0 liter on the way
- Nelson Tune
- TR224 for F-body....what for 5.3 Silv?
- Corvette or Billet Servo?
- Is my stock exhaust like yours?
- MAP Sensor code (P0106)
- Help me w/ cam (also -wtb ls1 cam)?
- About Cutting My Cats off
- Lapole Headers, Question
- turning over with radix
- gas mileage readout
- cammed 4.8 question
- 5.3 motor 6.0 pcm??
- Will towing a SS Imp hurt?
- Different approach to modding an LQ9???
- Transgo
- Wow!
- it's a race truck now, i just pulled the air
- 408 is done and running.
- LS1 Edit?
- Truck LS1, LQ4, LM7 Oil pan capacity?
- 3.23 to 4.10 Gear swap
- What do I need to know to delete tq management in Edit?
- Need Tire Opinions!!!!!!!!!!
- Auto trans shifting too hard after Engine Work
- Good day just got BAD!!!
- tuner that comes w/radix question?
- Got my truck Dynoed!
- building up a 5.3
- Max displacement from 4.8/5.3 block?
- Driveline vibrations
- Truck's taking a trip ... getting ready for the 80e
- Forced induction?
- 3200TT Yank converter in a 4L80E?
- Wanna Go Faster
- 5.3l to a 6.0l?
- Mileage question? New cluster.
- ?want to raise shifts on kenne bell whipple
- Damn The Luck!
- Weiand/Lingenfelter intake and BBK 80mm throttle body
- Nitrous guys, purge ???
- Efans, 110* outside temp..ok?
- K&N intake kit
- Leveling Front end with Snow Plow Prep Package???
- Paging BIG TEX!!!!!
- Header info?
- Another Cam Question
- Volant inductions, Nitrous Express and Predators on sale!
- 93 octane with HPP III and Preditor?
- AMW Catch can
- Tow Vehicle
- traction bars, what do you think of these ?
- Comp Cam info help...
- 5.3 liter torque improvements?
- Ok, vids maybe
- radix
- OPinion
- requests for nelson/whipple tune
- pretator programmer
- $80 1/4 timer toy worth it?
- Cats
- help
- hmm...saw an LQ9 in an extended cab at the chevy dealer today...
- Anyone relocate their ignition coils?
- plug wire clearance and asm's
- handheld (again!!)
- Part number
- F-body air lid
- Idle adjustment
- 4.10 gear ???s
- performance diff 22's vs. 20's
- Will a 2003 Engine work in a 2000 truck?
- thread pitch for HD tierod
- Paging 01 thunder
- got the new exhaust on---pics.
- It feels good to finally drive it
- Intercooler for the whipple
- New track times
- 1.982 60' time in 7500lb tank!
- I Need Serious Stall Opinions!!!!Please!
- Driveline Clank
- Reported H2 dyno results
- Wuwuahahahahahahah!!!!!!!!!!
- Gas Mileage
- Tranny Cooler Question
- Was the comp 212/218 high or low lift?
- More hp with larger injectors?
- Well, got to pull a head. Need some advice.
- Drivetrain problem/question
- transgo question
- question about fastest truck list
- Just a few small questions for the ones who might know.
- Sway Bar Question(s)
- Another tranny question.
- Taking off the tranny pan on a 4wd
- Anyone change cam bearings???
- are the times ok???
- Hyper Tech programmer
- Went down the track for the first time ever!
- new times!!!!
- Top or bottom line for Tranny Cooler?
- Will the LQ9 drop right into the 4.3's spot?
- What are the differences btw the 4l60e's?
- front axle actuator, rebuild ?
- E-Fans Trouble!!!!!!!!
- Impressions Of The Comp 212/218 114lsa Cam
- Anyone using the Bully Dog Allison Shift Enhancer?
- Hand helds
- HELP brake bleeding question
- How to adjust transmission
- Header questions...
- questions on cams
- Is this true? new tuner?
- Very surprised tonight......brake stalled stock torque converter too 2500rpm!
- Guys with higher rpm cams, how do you keep an eye on rpms?
- custom cam grind
- 35 or 50 shot nitrous. EXACTLY which system?
- 180* Thermostat questions
- 3.73's Not Available With the L33
- Dakota RT
- E-fan pigtails?
- Just got back from MTI's Dynojet
- tweaking Nelson tune with Predator
- Tranny Question
- Best Muffler shop in Houston
- dish amount on LQ4 piston?
- throttle body spacers
- New Dyno Numbers 549rwhp and 564rwtq
- Free Mods
- Will my cold air swap over ?
- FREE Set Of AS&M Headers With every Radix Or Procharger purchase!!!
- July Sale of the Month - 10% off all headers!!!
- Weight Reduction Thread
- Whipple handheld programmer
- 5-speed needs new clutch!! How much?
- Drop Kit Rubs Front tires on Bumps!!!
- Getting my truck dynoed!
- Headed to Ohio!
- Question on blocks???
- Zex Nitrous
- Basic's
- Diesel Truck Pull SoCal Sept 19!!
- anyone heard from allen nelson ?
- Shocks...what are you running?
- Radix Guys: What Fuel to Run
- I Got Ripped Off!!!
- Got my cam and springs in today, tomorrow they're taking another trip!
- LQ4 vs LQ9 identification
- Pro star Xp rims
- How bad will I lose?? Update!!!
- what about this cam??
- 6.0 problems. help today only!
- Last Day for June specials at Thunder Racing!
- Getting some new parts....need a cam recommendation
- 4" Aluminum Driveshaft Too Much?
- Rear End Gear Change And Then Some
- how too swap in fbody
- Radix w/Head & Cam Question
- UP again.
- Cam For The 422?
- Deal or not on Duramax Silverado?
- Removing springs from a leaf pack...anyone see any problems with this
- GMPP intake
- Need some ideas
- exhaust question
- 6.0 swap complete
- KR Question...How do these numbers sound?
- New to this area.
- rcfast,got sumtin for ya.
- Radix Guys: How much boost???
- noob question...what are 'free mods'?
- a new thing for me in the SS
- Nelson tune
- Cel P0315
- I finally decided on a cam!
- How bad will I lose???
- Can I use the stock crank?
- Do Transgo Kits Break IN?????
- TPS codes (P0121?)
- WTF... Hedman headers for our trucks too?
- Help with LS1 edit on a 8.1 truck
- New Gears and PCM
- Who was askin about my VSC fuse holder?
- Check up?
- big truck vs 1/4 mile
- Putting the 4.8L on the Dyno, Thursday
- 20'S Performance Loss???
- Vortech, Paxton, ATI and Magnuson superchargers on sale!
- Sale on Hawk Brake Pads!!!
- Sale on Powerslot Rotors
- Stroker Assemblies on sale!!!!!