- Nelson tune for Whipple, updated
- Torque Management Removal
- Whipple active boost solenoid bypass (etc)
- what is best. ported TB or the VR velocity stack
- N2O filling station
- Gear/Tire size info
- N2O info
- Hey Dealership Guys, 05 ECSB L33 Exhaust?
- Removing EGR question
- what gears with this converter?
- any difference in 4.8l heads and 5.3L heads?
- They Make Pulleys For Magnachargers
- Carteks tuning my truck next week what you think for HP???
- Tricks for LS1Edit for novices?
- building my own dual pump setup
- Sale on Radix Superchargers!!!
- DynoTunes A/F ratio switch?????
- Guttin The Cats?
- 6.0l Burban vs. 8.1l Yukon
- What is all needed to swap in a 6.0 liter in a silverado.
- Supercharged 8.1
- ordered vhp cam today
- what 15" rim has the best chance of fitting?
- Tranny is now slipping bad on hard acceleration. How long till its toast?
- ORY pipes for Silverado SS?
- need specs for desktop dyno runs!
- How do I tell if my 00' Silverado has Posi or not?
- chambered pipe???
- Roller Rockers for $350
- LS6 on a 6.0L LQ9?
- Negative crankcase pressure....
- will i have problems with 2800 stall converter and 4l60 trans?
- Building a 327 (328) L Motor
- Instructions for gear swap?
- Bottle Mounting Opinions??????????????
- 1.85 rockers ?
- 18" nittos or 15" bfg's/MT street DR's
- Intake
- Nitrous or Stall?
- Factory 6.0 'Texas Truck'
- fact or fiction?
- MTI LS1Edit Truck Tuning - Special Pricing Til 9/17/04!
- max overbore on 6.0L
- got a engine question
- New To Forums, 02 Sierra 4.8 HT
- fuel pump fuel line fittings need info
- sts turbo
- Fluids?
- Thorely Tri-Y's???
- rear end fluid change after Eaton?
- shifts acting up
- Intake Manifold??
- Any Mods worth doing on the V6? :(
- Problem with my Ford....
- And easy IC for STS kits??
- twin turbos?
- catch can and air filter pic's
- 2001 Silverado LT
- will these heads fit?
- Eaton Posi
- Mandatory mods for 6.0 motor that is going turbo?
- 4.8 2004 vacuum pump
- Help on tuning issues
- Goodmark Hoods and B&B TriFlo exhausts on sale!
- Alright alright alright...22's DO hurt 1/4miles
- Should I put heads on an 80K 5.3 motor??
- Question for Parish
- How do you guys launch your trucks???
- Cutting weight - how to?
- Radix installed over a LS6 Valley Cover?
- Hooking up Alky. 2 questions
- Couple more questions....
- 1997 Chevy Silverado
- someone please answer my qestion about radix pulley
- Ok, let's try this again.lol Anybody try the JETHOT coating on headers?
- got a question about the rear O2 sensors?
- what would cause this?
- Ebay Supercharger
- Anybody get the kooks coating done?
- Any Free Mods For 03?
- Verdict on Corsa and Volant
- Taking off cats...quick question....
- Where to buy GM Melco Truck Coils online?
- My Secret Plan Exposed!!!
- Help!!!!!!!
- questions about the old side-mount magnacharger systems
- Finally got my LS1 powered Truck done
- Will the 10.4 taylor thundervolt wires from a LS1 work on a 6.0 truck??
- Cam for F.I.
- Aero Chamber mufflers?
- 3.1 pulley
- Thorley owners got a few ?s
- STS Turbo Specs
- joe gibbs reg cab 1/4 mile times?
- The #'s are in!!!!
- 6.0 underrated? dyno results.
- Newbie Needs Direction
- KR with sensors unplugged??
- What is retarding my timing?
- Want to Make tranny stronger?????
- My LS6 cam is in....
- Yank TT3000?
- Finally Dyno tomorrow!!!!!!
- It's Alive! Installed engine on Thur
- Vortech and Paxton supercharger Group Purchases!
- What will this thing run...
- The VaraRam King Cobra indiuction has arrived!
- Best headers for a 5.3?
- Intake Swap. The final Solution?
- Needing some help on an 8.1...
- MTI Now Offering LS1Edit Tuning for Trucks! - How about a special?
- 4" single exhaust
- putting 5.3 in a 94 chevy
- LS2 Colorado?
- ? about a 6.0l
- Traansfer Case Guru's ---> haaaalp :)
- Finally ordered a Nelson's
- Looking for cam options for my 02' Denali P/U
- Dyno Results
- STS Featured in Sport Truck and Turbo Mags
- VSC crapped out, need some opinions
- Rpms with 3.90s
- where to buy a "hobbs" switch
- Best way to make trans stock?
- Frustrated with new 1/4 time
- Boost Controller with Centrifugal SC
- Racing Tires
- Tire question
- Perfect heads for 4.8 with Comp 212/218??
- Whipple Users Please read
- 150 shot off the line?
- heads/cam 6.0l
- '05 ssr with ls2
- High Performance 8.1
- Question about B&B exhaust
- Truck finished for now... Question though
- Kenne Bell
- Pushrod length
- What Cam / transgo question???
- Transgo/Vette servo question
- Walbro 340 on 04 returnless fuel system ???
- Oredered my HPTuners VCM Suite today!!!
- FlowTech shorty headers
- HDs only have a 6.0 or 8.1 motor correct?
- 6.0 Motor swap
- Looking for Truck Edit???? Come inside...
- 160 thermostat for the 2004+ trucks
- Which setup would be best?
- Nelson Tune for these mods?
- Speed Limiter Needs ELIMINATION!
- Trans go install????
- help wit RADIX 4.8 hp numpers please
- 4.8/5.3/6.0 Specs, etc.
- Long tube headers for the 8.1
- want to bail on the 10 bolt
- Torque Management?
- SMC selonoid?
- IAC's and drive by wire TB.
- PVMuffler
- Having tranny problems, need some help.
- Trailblazer Mod forums?
- 04 160 deg thermostat
- going from cable throttlebody to electric
- 408 up & running...vid/audio
- 3.73 vs 3.90 ?
- I Need Ur Help On A 01 5.3 Sierra
- Dyno tune with Allen tomarrow
- Flowmaster exhaust kit help
- Need some help with tune and e-fans
- What Size Pipe To Run With 422
- Paging: Goshawk
- Engine won't start
- Need Help On Cam And Intake
- Intercooler Question?????
- Will injectors work???
- 6.0L LQ4 poor idle
- Heads/cam are on... got problems!
- fUEL PUMP UPGRADE
- Which plugs w/ nitrous?
- Compression Ratio and Boost...
- Flowmaster Super 40
- Magnaflow muffler with a turn down
- Bad Ass '05 Performance
- What size Cone filter do I need?
- pcm blue #42 and what is the other wire for a 2 stage fan selection for ls1 edit?
- 4 Cross Drilled Slotted Zinc Plated U.s. Made Rotors W/axxis Pads 299.00 Shipped Look
- best free mods for a 04 5.3
- Blower Cam Good for Low-End TQ...?
- Anyone had experience with the Vararam intakes
- It's running again
- 6.0 and 60E question...
- who makes the best long tub headers and throttle bodys
- LS2 based truck motor question
- CROSSPOST: FLP vs. Rossler vs. Local shop + parts
- STS Turbo Questions For The DYIer
- Noise/Vibration when banking right.
- JBA headers and Predator programmers on sale!
- My truck rides like poo!
- Which Motor
- 80e is in and running ... FINALLY!!!!
- couple questions really quick
- Looking for cam specs for stock 6.0 motor.
- How much do these weigh?
- What gains to expect????
- in jacksonville today
- got my problem fixed
- Silverado SS, TR220, installed.
- Custom Exhaust Headers
- O2 sensors
- Hypertech/ Vin# Problem Please help
- 15# on 8.2:1 5.3 or ?# on a stock 6.0??
- What should I get?
- ZL 402 by tbyrne
- G5X3 in a 5.3L
- Noob question
- What trans do i have in 2000 silv
- Rear axle?
- Does Your AMW Catch Can Whistle?
- 6.0 w/ trans, ecu, etc.
- got some problems what do you think the damage is-long
- LT1 swap into 93 silverado
- Who's running ET Streets?
- Will a Turbo 400 Trans. Fit?
- Switching to Magnaflow
- code P0113
- Strange Boost Action
- new track times...
- 408 is finally in - got a problem.
- Tranny Help Please
- Camshaft and Rocker arm upgrades
- Efan install?
- Guys need some exhaust sound clips
- 402 short blocks for under $3500.
- What is the max stroke of the 6.0L?
- Took the plunge this afternoon...
- Baer's Alumasport brake packages are available!
- Best place to by a Diablo programmer??
- 11.63 at 117mph
- Wheels Question
- REar end problems
- New 3v F150 Whipple
- Cam and converter
- New to the Board.
- 383 ram jet in 2003 silverado?
- LS1 in a S-10/Sonoma
- 4L80e Trans. upgrades for 6.0 (408ci) 450+ HP
- Cam vs Stock computer... will they get along ok?
- hey black, how's that intercooler?
- TA Rear Diff Cover
- 4" cut out is huge!!