View Full Version : FORCED INDUCTION
- s475 spool
- 2000 sierra 4.8 build advice?
- Boost on my 98?
- Big ole girl
- 1st Time @ the track with Turbo Kit
- Vac/Boost gauge in 99-02 cluster
- Straight Meth or Mix ?
- Nitrous and turbo
- What's everyone using for methanol control?
- Compounds?
- 454 TBI Turbo build
- any one know if the Magnuson Kits come with a crank pinning kit?
- Afr up down
- What happens when injectors pass 100%?
- LY6 boost limit ?
- Backpressure Testing With New Hot Pipes
- Turning up the boost
- hks evc-s tuning. HELP!!!
- Holley LS3 manifold machining problems
- Whipple Service
- pdf for flipped manifold flanges?
- Maggie 112 78mm to 90mm?
- gmt900 mass air meter mounting guestions
- Vic jr with 4150 Tb or Holley tunnel ram
- EVAP System w/ Boost
- maggie alternates
- All oem 90mm tb's interchange?
- Has anyone bought from catchcans.com?
- MAP Sensor
- List of stock bottom end and boost pressure?
- Borg Warner S300 opinion
- EPS truck torque 1 cam for supercharger application???
- Injectors
- Critique this PCV Setup
- On3performance junk!!!!
- Boost gauge install ?
- Cold Piping
- very disapointed dyno #ers
- 2008 LY2 4.8 LS9 cam?
- wastegate size?
- Turbo time. yeaaaahhh
- CRAP!! Can't decide between Turbo or Supercharger
- rebuild what rings? for boost
- boost controllers?
- 4.8 4l60 vs 5.3 6l80 Turbo DD
- Howdy!,need opinions
- Low mount turbo
- 8 Rib Install / Pictures
- lq4 with s475 idle video..01 blazer xtreme
- Big turbine Borgs
- Thinking about a different cam
- Results in! 4.8L w/ Magnum 76 Exhaust Pressure Test
- Turbo housing smoking
- turbo lq9
- Trick kit is almost here! Have a couple questions...
- modifying shortys for turbo?
- what s/c for 04 1500
- how much power can a p1sc support
- Done deal.. Maxed out 4.8L/76mm Magnum. Next?
- 2005 and newer LQ4's boost limits???
- Safe boost with no meth?
- help with head choice
- extending heater heater core hose around turbo
- Another 4.8 turbo build
- what size turbo? 6.0
- high ltrims
- 05 vette cast manfolds work for turbo?
- Wastegate
- Trick oil kit.
- getting blowby
- 3" to 3.5" v-band adapter?
- Can tires eat that much power?
- turbo cam selection?
- 07 procharged truck ?'s
- A cool read, some good info too.
- magnacharger 112
- 03-06 gmc grille mounted intercooler size?
- Opinions on EPS spec'd turbo cam
- Slp tvs 1900
- Bad Brakes after Turbo Kit almost Killed Me !
- Kit for 02 fit 05?
- dual bov?
- 2300 too big for 5.3?
- 8.1l high boost
- Running a Turbo PCM and set up with no Turbo???
- bov vavle selection
- Magnacharger question
- What size turbo for rear mount?
- how to increase fuel economy with a turbo
- Overboosting problem with free flowing exhaust
- Borg Warner recommendation for 5.3L
- Procharger Filter Setups (Post your pics!)
- single duration cams on a turbo L92 heads 6.0??
- Plug wires with flipped truck manifolds?
- Quick spool valve...does it work?
- has anyone seen this turbo kit?
- Compression Ratio with Turbo
- 454 SS Single Turbo build
- Made it 15000 miles, then this
- the time has come to upgrade again ,f1r + cog driv or turbo , opinions wanted inside!
- 5.3 popped at 7psi, why?
- 8 Rib Leftcoast32 setup
- apillar gauges pics on nnbs
- which turbos for twins on my 4.8
- Who's boosting L92's?
- time to swap
- Just Back from the Dyno
- need rps BOV sound clip
- Need some advice on Turbo
- Flipped manifold kits...
- Propane Turbo 5.3 first track day video
- 706 Heads with Boost?
- Just another 4.8 turbo truck. 2007 RCSB PIC HEAVY
- S480 v-band outlet...Why???
- Dyno day
- bogging under any kind of acceleration.
- Oil Temperature
- Vacuum Port
- Turbo heat management ideas
- sts and nnbs intake
- Who is running a 4" muffler with Turbo??
- Maggie 112 8 rib Pully or 1.1 cog set up
- Turbo set-up question
- #of idlers?
- whipple install help ??
- Brake Boosting My Truck Video - Help
- Green spark plug strap...
- Retune from .81 a/r to .96 a/r?
- Boost/belt question on 2300 maggie
- Ssr 5.3 work with silverado 5.3
- Rear mount turbo from scratch
- What's the difference?
- Dyno numbers are in
- Rear mount turbo a/r sizing?
- What do you think about this cam??
- From rear mount to front mount, new tune?
- help me identify if this is a ls6 cam
- what BOV .. quality etc
- $24 to lower IAT's on my MP112
- a turbo kit someone offered me
- the normal "oil residue in the charge pipes" and MAF question
- Colorado/Canyon 5.3 Turbo Kits?
- PCV check valve
- blow back
- alky control
- Computer Overriding Power Enrichment under part throttle
- Maggie on 6.2
- need some questions answered about p1sc setups.
- Worlds quickest and fastest stock bottom 4.8 finally went BOOM details inside
- 6.2 Turbo Cam
- Wastegate and manual boost controller questions.
- small efans for procharger intercooler
- Boost Cam help
- Low boost on 5.3 with mp112 3.3
- twin turbo 04 SSS
- TVS bypass valve
- Left Coast '32 Is Back!
- Converting Eaton MP112 from Ford to LS?
- Plug Gap
- Mahle or diamond pistons for boost?
- Turbos not spinning at idle??? Help
- 408 help
- Need a Turbo installed on a 4.8
- Almost done w blower install, have a question
- Wastegate pumbing
- Bracket for paxton
- 07 vortec max turbo help
- Max PSI
- Turbo 6.2
- If you TOW with a Maggie, post up your results
- Spark plugs
- Got that dual exhaust!!
- 2004 denali with radix fuel issues
- Hey guys, new and need some help
- Post Your Magnuson Engine Bay
- What is going to hold me back?
- To much heat or maxed out heads
- Who is running 10.0+ CR with boost???
- Any blown street trucks running 10's w/o Nitrous?
- Radix is on, Here I go thinkin Part II
- Deciding
- What turbo lag?
- Any body running theses kits
- turbo help
- 6.2 turbo build
- Real life dyno numbers??
- highest boost from 6 rib
- Roush owners, need help w install
- How far to push it?
- which brand injectors?
- Wires/tubes through the firewall?
- TrickPer Turbo Kit IC Setup
- How much?
- Hot pipe turbo kit?
- Engine/turbo break in
- 3rd and hopefully last tune.....
- Turbo 4L80 gearing. Need some input from the truck guys.
- Installed procharger, gettin misfire bank one
- Your thoughts. Best for boost and why? 4.8, 5.3, 6.0
- Weird AFR change...
- whipple install help
- Stock manifolds, can they be cut & welded?
- Turbosmart supersonic BOV
- Turbo Selection Poll
- Here I go thinkin
- Turbo LM7 advice
- came across this web site... ?
- The 4.2L I6... Any potential
- Iat sensor
- A few procharger questions
- 05 Maggie 112 Setup on a 99 Return Style?
- Black smoke at WOT?
- Supercharger Spacer?
- Bov???
- Help me ID this Tensioner...
- Open waste-gate with KB kit?
- headers affect on supercharger
- what size intake manifold- 92mm or 102?
- 6.0 MAGGIE 112 E85 conversion
- What would cause an increase on Boost(psi)
- Boost level
- DP heat blew up my ac line
- ugh still problems
- Negative timing while shift
- Looking for some twins
- what size injectors for 6.0 maggie and e85
- o2 sensor placement??? on FI setup
- cam for a whipple
- #60 injectors ANY GOOD ??? ebay link
- 70 or 76? Or something else?
- Question for the turbo guys
- Turboed 5.7 or 5.3
- Approx boost with mp112
- Compressor wheel rubs inside of housing
- would you drive your truck without a tune?
- TVS 1900 - how does the bypass valve attach?
- turbo afr vs kpa
- on3 76mm , THoughts???
- Opened up my TVS2300
- 2009 silverado, 4.8 powerdyne stock tune, please advise
- MAF Flange
- divided turbine housing
- New turbo!
- anyone experiment with their air/water IC
- expandafoam in fenders with supercharger install
- Pcv
- Procharger setup for sale
- A little update on my cc
- draw through MAF with turbo
- more boost from whipple? also low vacuum on the highway