View Full Version : FORCED INDUCTION
- Which a2w kit for supercharger?
- Looking for help to decide what supercharger to buy
- Finally running!
- Would setting up twins like this change the performance in any way?
- is this boost safe
- A/C With Turbo?
- which turbo size? gearing? and stall?
- IAT's too high???
- Turbo inlet air filter pictures
- Turbo Questions (TC guys help me out)
- whats the best exhaust setup for a turbo 6.0?
- Ls9 head gasket
- Backpressure and Intercooler Pressure Drop
- Methanol Pre-Turbo
- Cam question
- where's the best deals on superchargers
- Whipple 2.9L on a truck
- tvs2300...i want one, but how?
- Turbo!
- T3/T4 turbo
- Forged pistons necessary?
- High boost misfire. Help
- Factory Bottom End Plus Boost????
- blower help
- Timing vs Boost vs E85
- Am i expecting to much?
- dp fender exit
- Head Studs
- Engine cut out after turbo kit install
- Foaming white coolant/water in TVS 1900 resevoir
- need a little turbo help
- 700hp possible?
- Intercooler recommendation?
- 6,8 & 10 Rib Belt info
- 8 Rib Drive setup, who all makes them?
- Gains from Intercooler + Boost loss to expect..
- 30 inch magnaflow how quite?
- TBSS intake and TB
- sway bar with an intercooler
- 08 procharger on a 02 truck???
- Shims under LS6 springs with boost?
- Boost & PAC 1518's = 2 Broken Springs....
- newb with forced induction questions
- Z71 4wd turbo plan for DD and towing (and FUN!)
- Help Me Reach 500 Wheel
- which way to point my bov
- Anything wrong with this location?
- turbo at my tranny
- Nitrous Jet Restrictors
- COPO Whipple 4.0
- Who daily drives a procharged truck?
- How much heat wrap
- JE pistons
- 70mm Z71 w Trick Stage 2 dyno
- wastegate and bov hookup
- What 4" aftermarket exhaust will fit?
- turbo 5.3 help
- AEM Wideband Gauge...
- Building a turbo kit?
- procharger filter mod
- Whipple Owners
- heads and cam opinion
- iat placement ?
- Intercooled turbo iat?
- What kind of timing with 5.5psi on 5.3
- Heat shielding
- Possible new turbo from Turbonetics!!!
- Anyone run an electric WP w/ ProCharged truck set-up?
- Got new truck, Going FI in future, question about supporting mods along the way
- I have a boosted dilema. opinions please
- MP T70, cam and 9lbs
- Trick stage 3 on a h/c LQ4
- dodge cummins intercooler. whipple
- 6.2l or a new style 383 stroker motor
- 3.08's with a 6L80e and BOOST ???
- LQ4 boost ?
- 07 nnbs turbo help
- 6.0 boost cam
- Sidemount mp90 Need some help.
- Reduced engine power??? Help educate me
- What size Exhaust A/R?
- Front Mount ?s.
- turbo smoking
- Turbo drain flange
- who makes a better sc
- What else do i need
- 5.3 or 6.0 or 6.2 + Boost ???
- need some encouragement/ideas new project.
- looking for a supercharger
- Turbo Oil Weight
- One way check valve part number?
- Backpressure
- Turbo oil fittings and lines
- Whipple Pulley?
- Soon to be Boosted + CAM Need Advice
- e-85 experiment
- Thanks to trick performance and stock48
- Turbo Exhaust
- Next upgrade????
- Vortech s/c
- need help
- Paint for Hot Pipes?
- LS9 tvs2300 on one of our trucks?
- supercharged 6.0L build questions (what year motor should i get)
- turbo vacuum readings?
- Starting a new project. 4.8 turbo for sled pulling
- KB turbo pipes and 4L80 trans clearance?
- 8.1l whipple plus turbo
- 3.5" or 4" downpipe
- 4.8 Turbo (Coming Soon) Need Some Critiquing
- Anyone with experience in Turbo systems please read
- still chasing the cutout in boost at 5k
- Anyone have a MP90 Rotor pack lying around???
- High Oil Pressure ?
- Planning Turbo Monster Truck -- Need opinions/advice!
- Turbo/wastegate exhaust
- boosted head gasket and spark plug question
- Another 4.8 about to be in the 500 hp club
- 8.1l whippled WONT START rebuilt motor
- Random question/paranoia setting in?
- Fuel and boost on a 2011
- Timing+Boost+Octane
- magnum76 08' 5.3 results video 17lbs
- Intake Manifold Opinions?!?
- what FI setup complements my NA mods
- put a ported/spiral cut vmax motorsports throttle body on few questions..
- Nos + turbo
- Turbo kit for 5.3 help?
- What psi needs studs (lq4)
- Turbo owners advice needed
- ? On water meth
- crossover piping
- Wastegate upper banjo??
- Getting turbo kit and need injectors
- Hot side dilemma
- Radix heat exchanger inlet
- TVS2300 on my L9H??
- intake on 4.8 turbo
- TURBO On a DOD Engine???
- Change of plans... Swapping bump stick
- 8.1l whipple/ kennybell
- New intercooler and tailpipe!
- High intake temps, whats too high ?
- Are the spacers between intake and super charger working good how much are they!!
- oil + turbo question
- another "how far will the stock fuel system get me?"
- Intercooler pump wiring size
- Made the switch to the DARKSIDE
- Turbo tuning with Autocal
- cutting out in boost around 5K and up,
- Any turbo 5 speed trucks?
- proflo xt and new intake/cold side for the old turbo kit...
- Stock, non-E85, fuel pump good for any boost?
- Any single turbo s10's here?
- Hit 36 psi in my Dodge today
- 4.8 with 5lbs of boost....stock tune ok?
- Just bought a Trick Stage 2 Kit – any input, tips or tricks?
- Need help on new turbo build
- NA going to FI - Need Help Please?
- FI+built 4l65. Experiences?
- oil restriction
- 20psi on stock 4.8
- Any FI guys running LSXRT intake and 102mm TB?
- ? on TVS install on 11'
- just installed a D1 need some help guys
- 370 or 408 for turbo?
- Just Installed Stage 3 76mm Trick Perfomance kit
- NNBS Fiendly Fuel Pump
- Fuel pressure dropping while in boost
- Need Opinions on PCV
- Want to built turbo setup for a 4.8
- critique my PCV catch can F/I setup. getting blow by.
- Pics of pt 7675 cea turbo
- T4 turbos?
- What water resevoir for intercooler is bigger and plastic that i can buy!!
- stupid advanced auto
- School me on chemicals.
- sort of a problem with supercharger pulley. opinions please
- 07 yukon turbotowed 7600lbs enclosed 600miles, up 8% grade
- Blower loss of psi question
- new turbo needs injector upgrade
- Turbo cam installed!!
- Trying to understand cam overlap and boost
- Lingenfelter/ Magnuson Supercharger package
- blower knocking after cam swap
- Why does boost vary goes from 8.1 psi 7.3
- meth nozzle location?
- Be a problem to mount a turbo to y pipe?
- question about fuel pressure regulator
- pulleyed down and just look what happened ...
- relocating coils?
- Turbo Intake Manifold options
- how much boost will an ls2 block hold ?
- STS or Maggy
- Injectors
- Blown Avalanche
- creative gauge placement
- 5.3/tvs1900 swap question
- Max boost on P1SC on stock 6.0 with meth
- NNBS Dual pumper help??
- gains from pt 76/75
- Any Turbo Trucks in the Snow?
- What do you tune with??
- Which and what size turbo?
- Help on fueling
- 2 port BOV
- Radix Intercooler Pump and Intercooler.
- Boost bet with MAF or SD?
- turbo exhaust
- LS6 Head Gasket Question
- TPP Turbo kit install/build thread!
- BOV and MAF placement
- Blow off valve?
- FMIC guys
- Which IAT sensor? Where did you mount it?
- what exhaust/size are you running with Turbo
- Aeromotive 340 Pump and e85
- the procharger thread
- Boost on demand, CVT supercharger pulley
- Progress made on HD tensioner...
- possible boost issues
- Few Questions on a newly boosted application
- Westgate spring pressure
- turbo tuning
- Help with fuel pump/parts for tvs1900
- 4 barrel throttle body with boost...
- Positive Displacement Blower Options
- this kit anygood for budget?
- pressurized my coolant system ?
- twins???
- Porting behind T'body on TVS2300
- anyone using the pro flo intake??
- C6 LS2 Manifolds...
- wastegate into exhaust
- looking to cam my 4.8 on boost
- turbo advice needed
- extending 02 sensor harness
- who has lifted a 5.3 head?
- MAF or no MAF?
- has anyone built a spray bar?
- rear a/c line 2007 yukon...need help
- PCV Catch Can Setup
- possible new future set up. (need help)
- Cracked on Friday13th !
- 10-15 psi... what plugs?
- 10-15 psi... what plugs?
- Getting ahold of Trick performance?
- Safe to turbo 140000 miles
- Getting back in...
- Turbo cam with good torque and fuel economy out of boost?