Heads have been sold.

Wanted to see if anyone was interested in a set of heads I just recently took off my motor. These are 5.3L heads that were cut for 2.00'' LS1 intake valves that came out of a Vette with less than 5000 miles on it. The exhaust valves were also used and are the same size as the 5.3L valves (1.55'').

These heads also have Comp 918 springs on them, that can be removed unless they are wanted. The springs have less than 3,000 miles on them.

The heads come with everything except of course push rods and the rockers. Lastly, the heads have a mild valve job done and are milled .030''.

The stock castings cost me $100. They have $400 of work put into them. The springs were $150. With springs, I would be willing to let these heads go for $600 shipped. Without $525 shipped.

If there is any interest I will post pictures of the heads and then I can also scan the receipt of the work done to the heads.

-----

5.3L heads
-2.00'' intake valves
-valve job
-.030'' mill
-918 springs
$550 shipped

w/o springs
$450 shipped

Please PM me for the quickest reply,

Thanks,

Kyle

 

How much would that raise the compression level on a 5.3 or 4.8?

 

roughly .6 of a point

 

Sent you a pm!

 

The receipt.

 

Sent PM

 

TTT, new prices

 

New pm sent!

 

Chris, I don't think I received it.

 

So everyone knows. I have a few of you guys bidding on this and I will do things like this. First come - First serve. So, prices will not drop/increase. They will remain as is. I will keep this thread up to date, on whether or not these heads are going to be sold, and/or have been sold.

Take care guys.

Kyle

P.S. PM me for quickest response as always.

Heads were sold. Thanks guys.