Headlight Mod for $1
#21
TECH Fanatic
iTrader: (4)
Join Date: Jun 2003
Location: Chicago Burbs
Posts: 1,528
Likes: 0
Received 0 Likes
on
0 Posts
Ground the wire that comes from the box. The wire in the loom I just taped off. You'll see my wire is green from the box,m that's because I took the yellow wire out of the connector and just put a new wire that I ran to a ground point.
Andrew
Andrew
#22
TECH Apprentice
Join Date: Jul 2004
Location: Louisiana
Posts: 379
Likes: 0
Received 0 Likes
on
0 Posts
I have an 01 Seirra and my relays arnt setup like that. I have on big relay for hi and low lights and 2 seperate ones for drl and fogs. Can I still do the diode mod?? I just want my lows on with hi's and fogs on with both. I dont really car about the drls. THANKS!!
#25
TECH Fanatic
Thread Starter
iTrader: (6)
Join Date: Jan 2004
Location: New England
Posts: 1,444
Likes: 0
Received 0 Likes
on
0 Posts
Well......
I think you could.
I dont know anyone with a 99-02 near me in New England.
But, I think if you look in the relay box for the Highbeam and lowbeam relays. Find the signal to the relay coil. Put the Diode between the signals. That should work.
Anyone have a 99-02 near me that wants the mod for free, I'll do it for ya?
The yellow wire is a MUCH easier mod to do though.
I think you could.
I dont know anyone with a 99-02 near me in New England.
But, I think if you look in the relay box for the Highbeam and lowbeam relays. Find the signal to the relay coil. Put the Diode between the signals. That should work.
Anyone have a 99-02 near me that wants the mod for free, I'll do it for ya?
The yellow wire is a MUCH easier mod to do though.
#26
TECH Fanatic
Thread Starter
iTrader: (6)
Join Date: Jan 2004
Location: New England
Posts: 1,444
Likes: 0
Received 0 Likes
on
0 Posts
Further Understanding
The diode has one side that has a white bar. The white bar should go twards the High Beam signal (T1). The bar should always point twards the trigger. The other end of the diode should be in the Lows (B4) And ANOTHER diode should be used for the fogs, with the bar twards T1 like the other. But this time the other end goes in the Fog (B5) Like the Attached Pic.
The diode has one side that has a white bar. The white bar should go twards the High Beam signal (T1). The bar should always point twards the trigger. The other end of the diode should be in the Lows (B4) And ANOTHER diode should be used for the fogs, with the bar twards T1 like the other. But this time the other end goes in the Fog (B5) Like the Attached Pic.