Converter is gone

I also have the 5" driveshaft that I had built from Driveshaft specialist out of San Antonio. 1350 Ujoints, high speed balance etc. I paid a little over 700 shipped. It has about 25000 miles on it. I'll take $350 you pay shipping for the driveshaft. It fits a crew cab or ext cab 4x4. Center to center ujoints is 68 1/2"

 

Glws buddy!

 

That is a good deal on that driveshaft ... someone needs to grab that ... my 5" DSS shaft is awesome .. GLWS ..

 

If I had a stack of cash laying around I would love to pick that DS up.


Have the same converter though, excellent setup. GLWS

 

Thanks fellas

Bump it up to the top!!

 

 

Will this fit a NNBS 4x4 CC? I'm 1200 miles from my truck and my tape measure is a bit short to measure from here!

 

According to his post on Facebook it fits 4x4 ECSB and CCSB 143.5 WB if that helps.

 

Based on HAMMER's measurements a GMT900 CC 4x4 is 67.5", not sure if its due to trans length differences or what but 143.5 wb is mine from what i recall. so... I think its too long? Anyone confirm? What trans did you have with this 4l60?

 

Yes 4l60e 4x4. If anything they could shorten it for you. Give em a call and see what the price is shortned and add it up... It might still be cheaper then buying new? LMK