Has anyone ever had a problem with the bar being too long? After both front and rear brackets installed there is no way the bar will go between them. I have the heim joints threaded in as far as they will go and the nut on the rear heim joint is hitting the eye hole bracket under the axel. its a good 1/2 to 3/4" too long. Even if I found a way to squeeze them in there there will be zero room for adjustment. By the way this is on a 92 swb pickup with a flip kit. Yes the kit is for a flip kit. iv tried loading an unloading the suspension and the distance doesn't change.

 

they do make mistakes....they sent the wrong aluminum bushings for mine.....i had to have them machined down to fit.

 

the only thing I can think is they sent the wrong link. Im going to call in the morning. I was just wondering if anyone else has ever had this problem.

 

What does the bracket look like for the flip kit? Can you post a pic?

 

this is not my truck but the same bracket. go down to post #15. It has a flat plate instead of the rounded bracket

https://www.performancetrucks.net/fo...-462149/page2/

no flip in post #2

what traction bars are you using?

 

hey man, you sent me your new number, but I can't send you a text for some reason. Did not want you to think I was blowing you off. Send me another text and let me try again. laster, Rodney

 

Did these bars work before the flip kit? I'm not sure if the 92 needs a shorter bar or not. Have you contact Calvert Racing?

 

Mine was also hitting, would not allow it to adjust.. I just took and cut about a 1/4 inch off each end of the bar.. Fixed the issue.. The pass side fit perfect, didn't have to do anything to it..

 

Thanks mangled. I may have to do that. I haven't tried the passenger side yet. I would hate to have to cut them up though. And AKlowrider I did not have caltracs before I did the flip kit so I orders them knowing I was going to do the flip.

 

Any chance that the hole on the leaf spring bracket would be farther back if you 180-ed the bracket?