FS: 1970 Chevy C-10 W/ 6.0/ 4L80E Swap-Charlotte, NC
Feb 16, 2010 | 09:52 PM
#1
Thread Starter
TECH Apprentice
iTrader: (2)
Joined: Jun 2003
Posts: 338
Likes: 0
From: Charlotte, Nc
FS: 1970 Chevy C-10 W/ 6.0/ 4L80E Swap-Charlotte, NC
Name: Dereck
Location: Charlotte, NC
Contact: DereckFichtner@aol.com
Vehicle: 1970 Chevrolet CST-10
Miles: 93,887
Title: Clear, in hand
Price: 11,000 OBO
*2002 6.0 Liter Engine and 4L80E Trans
*Custom Tucked wiring harness and fuse box
*LS1 Dual Electric Fans
*New Inner/Outer Tie rod ends
*New Upper/ Lower Ball Joints
*New Disc Brakes in front
*New Master Cylinder
*New 2 1/2" Drop Spindles
*Air Cab
*Clean, Fresh Interior
*Factory Tach
*All gaskets in motor are new with the exception of the Head gasket
Truck has lots of new parts, just needs a little time and money to get it on the road and have a nice driver. The body is solid, only has a little bit of rust on the cab, nothing major. I have a lot of money invested in this truck, but not have the funds to finish it, so i would rather see it go to someone who can finish it and enjoy it. It will need to have the driveshaft shortened to fit, relocate gas tank under bed and install electric fuel pump, exhaust ran, needs headers, already have flowmasters for it, needs Locar shifter and trans dipstick and brake lines in the front. If you have any questions feel free to email me and I will answer any that you have.
Location: Charlotte, NC
Contact: DereckFichtner@aol.com
Vehicle: 1970 Chevrolet CST-10
Miles: 93,887
Title: Clear, in hand
Price: 11,000 OBO
*2002 6.0 Liter Engine and 4L80E Trans
*Custom Tucked wiring harness and fuse box
*LS1 Dual Electric Fans
*New Inner/Outer Tie rod ends
*New Upper/ Lower Ball Joints
*New Disc Brakes in front
*New Master Cylinder
*New 2 1/2" Drop Spindles
*Air Cab
*Clean, Fresh Interior
*Factory Tach
*All gaskets in motor are new with the exception of the Head gasket
Truck has lots of new parts, just needs a little time and money to get it on the road and have a nice driver. The body is solid, only has a little bit of rust on the cab, nothing major. I have a lot of money invested in this truck, but not have the funds to finish it, so i would rather see it go to someone who can finish it and enjoy it. It will need to have the driveshaft shortened to fit, relocate gas tank under bed and install electric fuel pump, exhaust ran, needs headers, already have flowmasters for it, needs Locar shifter and trans dipstick and brake lines in the front. If you have any questions feel free to email me and I will answer any that you have.
