If anyone needs any exhaust work done in dfw me and Brendan are pros. Here's a pic of our handywork. This is a custom fabricated flowmaster install.

 

Holy hell... WTF did you use a torch and coat hangers (BTW i have used that combo before )

 

Haha it was a cheap little welder Brendan had. We had to butt weld the turn Downs cause they were the same size

 

An easy fix for that would have been to cut a piece of pipe about .5-1.0 in long and cut it down one side. Then wrap that piece around the two pipes the weld each side. Yall could have come over and borrowed my welder, chop saw, tools and used my garage but i am a little far away.

 

I have a nice welder, and 5 min from ur work.

For people that do not know how to weld....band clamps.

 

It doesn't leak so at least its functional

 

Where you get the muffler from? I need one n dont wanna spend a lot of cash for it.

 

Lol from you

 

Some quality work right there.

 

The good thing about a dumped FM is that odds are you would not hear it leaking anyways.