Spring selection for Precision 46mm
#1
Spring selection for Precision 46mm
Guys I have been puttsing around on a 3lb spring, I'm headed to dyno this Thursday. I have an Innovate SCG-1 controller. I want to make 10-12psi, but I don't want to hassle the tuner with a spring change on the dyno. I was thinking of combining the 'natural' and the 'green' springs, the chart says 10.5psi, and then using the boost controller above that. Does that sound reasonable?
Thread
Thread Starter
Forum
Replies
Last Post
LARRY01Z28
Tuning, Diagnostics, Electronics, and Wiring
14
05-02-2016 10:37 PM
JCunningham
GMT 900 Trucks General Discussion
2
03-17-2016 04:48 AM