I just got some 2" drop spindles put on my truck this past Saturday and I was wondering what could be causing the front of my truck to sit lower on the driver's side? It wasn't like that before the spindle install. Can something be done to level it out? Thanks!

 

did you have to pull the springs out for the spindle install. maybe the passanger side springs isnt sitting in the cup right

 

I don't know if the springs were pulled to do the install. I took my truck to a shop to install the spindles since me and a couple of buddies of mine couldn't get the stock spindles off.

 

I'm with z284thgen, the spring may not be seated correctly if it wasn't doing it before the install.

 

call the shop and ask them if they had to remove the spring for the install. and if they say yes then tell them one side is higher then the other and you want them to check the springs and make sure there installed correctly. any good shop shouldnt have a problem with doing that. and if they do have a problem i wouldnt reccomend them to anyone any more

 

Its called Chevy lean and it sucks!

 

Very common problem, mine is 3/4" lower on the drivers side.

 

Well found out what the problem is for now. It seems to be the "Chevy Lean." Yesterday my low fuel light came on and I noticed that the front was now sitting level. Of course I can't drive around with an empty gas tank so I had to put some gas in and now it leans. I still haven't gotten my truck aligned but will be getting it done this Friday.