Lol. No worries. I'm just kidding too.

 

Lol at the extra capacity.

At least it looks good!

 

Just a random memory of you asking about this. Truck was maybe ¼" from bumb stops. Looked at the bushings and they were just a little squished but now that trailer is off, back to normal.

 

I didn't like that much☝️☝️ so, I ordered parts.
And not just air assist...

 

Little bit to show

 

Little more

 

Nice fab work but I am curious to see the entire system though. I am not quite piecing together how it is going to work with the parts I see in the pics.

 

Drool.

Wish I had a daily so I could drop the truck off and let you do some building on her.

 

Ya, I'll be getting there eventually. The top link will be a bag on bar design. I did that to try and help it not ride like a dually but still keep some load capacity. I will cut off leaf spring mounts and weld on new tabs. My traction bars amd frame mounts will be similar but upgraded from aluminum to chromoly. Lastly a panhard bar.

 

hahaha, I move too slow for most people. I still have a lot to do to my project. Phase 1, complete fab and powder coat. Phase 2, install and run shrader valves. Phase 3 install tank, compressors, level sensors, wiring and hard line.

But as mentioned, I will no longer need my aluminum traction bars and mounts...