I hope I'm not late for work!
#1
I hope I'm not late for work!
The blower build starts HERE
My original build thread (prequel to this thread): https://www.performancetrucks.net/fo...slower-479366/
Well long story short I bent the crank in the other engine. Ran a best of 6.39@108 I think last fall. I have done a lot of changes since then including better rear shocks, 5" downpipe, coilover front swap, and Im sure other stuff im forgetting. In February it put down 820rwhp on a dyno dynamics I think. Boost was falling off so didnt really get a solid run. And my trans was slipping as it turns out. Ive had the trans and turbo both rebuilt since then and just been waiting on the engine.
I sent the engine back to LME and had them rebuild it reusing my rods and pistons. I had to get a new block unfortunately but this time I have a dragonslayer crank, gas ports on the pistons, and one of their billet reluctor wheels.
I have been working on putting it togther today...someone looks angry...
Might go in tomorrow! Goal is to be driving by the end of the weekend.
My original build thread (prequel to this thread): https://www.performancetrucks.net/fo...slower-479366/
Well long story short I bent the crank in the other engine. Ran a best of 6.39@108 I think last fall. I have done a lot of changes since then including better rear shocks, 5" downpipe, coilover front swap, and Im sure other stuff im forgetting. In February it put down 820rwhp on a dyno dynamics I think. Boost was falling off so didnt really get a solid run. And my trans was slipping as it turns out. Ive had the trans and turbo both rebuilt since then and just been waiting on the engine.
I sent the engine back to LME and had them rebuild it reusing my rods and pistons. I had to get a new block unfortunately but this time I have a dragonslayer crank, gas ports on the pistons, and one of their billet reluctor wheels.
I have been working on putting it togther today...someone looks angry...
Might go in tomorrow! Goal is to be driving by the end of the weekend.
Last edited by Atomic; 03-16-2016 at 12:16 PM.
The following users liked this post:
NIOMARVIN83 (07-23-2021)