hey guys i just got my Mcgaughy spindles shackles and hangers and was wondering if i needed any special tools for the install. Just wanting to make sure im not going to get halfway through it and not have a special wrench.

 

anyone?

 

the shakles u can do ur self..as far as i know..the rest im not sure...

 

it can all be done yourself, need pry bars, impact gun, air hammer for taking out the rivets on the hangers, some wrenches, o and some jacks and jackstands thats about it

 

I'd look into a ball joint seperator for that spindle job... And if I ever do another set of rear hangers in pulling the bed and torching everything I can... Just be careful of the gas tank :boom:

 

i didnt have any problems with my ball joints, just used a jack under the spindle and a BFH to beat them out, helps if you have someone who knows what their doing

 

set of deep sockets and jack/stands. out back angle grinder or good drill with a few bits and an air hammer