New PB 05 crew cab 12.90 at 107.8
#1
Thread Starter
TECH Fanatic
iTrader: (2)
Joined: Feb 2006
Posts: 1,089
Likes: 19
From: NewBern NC/Lake Havasu City AZ
went to the track today in my quest for 12's. Above 5000 my injectors are at 122% so my shift points were set to 5500 and max boost is 5 because of it. Time slip goes as follows, totally stoked to get 12's with such a **** 60 ft and not being able rev her out, but hey i felt safer.
.293
2.035
5.436
8.328
85.1
10.74
12.90
107.8
Still waitin on some mickey thompsons so im spinning bad, not being able to stall. ran with the 20's up front and stock 17's with nittos on rear. Full wieght, subs and all. heres a vid of my run against a fox body
http://www.youtube.com/watch?v=BYaagtE7bfw and heres a 12.98 at 106.6
http://www.youtube.com/watch?v=i2_COsJDzFg
.293
2.035
5.436
8.328
85.1
10.74
12.90
107.8
Still waitin on some mickey thompsons so im spinning bad, not being able to stall. ran with the 20's up front and stock 17's with nittos on rear. Full wieght, subs and all. heres a vid of my run against a fox body
http://www.youtube.com/watch?v=BYaagtE7bfw and heres a 12.98 at 106.6
http://www.youtube.com/watch?v=i2_COsJDzFg
Last edited by fastjweb; Feb 22, 2011 at 07:01 PM.
Trending Topics
#9
Thread Starter
TECH Fanatic
iTrader: (2)
Joined: Feb 2006
Posts: 1,089
Likes: 19
From: NewBern NC/Lake Havasu City AZ
its not slipping, the trans is set for a 32" tall tire for my 20's and i was running 26" nittos so it was jackin up the shifts pretty good. Thanks for the comments, i hope with a set of 28" MTs on some 16" rims and the injectors ill be able to get low 12's. my fastest 60 ft was 2.03, and i couldnt stall it.
Thread
Thread Starter
Forum
Replies
Last Post
FlowmasterMufflers
Dodge Engine & Exhaust Performance
0
Sep 11, 2015 03:32 PM




