okay so my 3-4 clutches were going bad so i drove home to my garage. all gauges worked. that being said i pull the tranny take it and have it rebuilt and put it back in and do the normal fill the tc up and add 5 quarts of fluid go and start the truck and notice every gauge in it doesnt work??? neither does prnd321 so i bought a new neutral safety switch didnt fix it. sooo i go ahead and leve it running in neutral fill the fluid go down the road and only have 1st and reverse???? any help appreciated

 

have you checked to see if you pinched wires in the bell housing to the engine?.. happens more often they you would think if your not paying attention to them

 

i didnt see any pinched but i will have to go check again with a flashlight cause its dark and rainy here

 

check that and all your fuses..

 

any specific fuses or just check them all?

 

not enough knowledge to say a specific one so i would just check as many as you can after checking for the pinched wires..

 

okay well im gonna drive a few miles then ill report back

 

Did you remove the ground on the back of the passenger side head for any reason?

 

I second that. I think it might be that ground strap many forget about at the back of the head.