This is the Driveshaft hoop:

We actually went back and doubled the thickness of the driveshaft hoop after I took the pictures. Everything is back from powdercoat.

 

Joe, I notice you're doing an SFI bellhousing. What class are you shooting for. You might need to look into a blanket for the trans, too

 

We are just trying to meet all the safety requirement so we dont get shut down for going to fast.

 

Updated with more pictures.

 

Truly one of a kind,the attention to detail is overwhelming.
Looks fantastic!
Great job, Joe!

 

Here are some pictures of the Rear Bumper Support with NHRA Legal Kill Switch and Jumper Posts. I got it back from Powdercoat, finished all the wiring and reinstalled the bumper cover.

 

This is the (prototype) Air Box from Cold Air Inductions Inc. for the MPD1 Functional Cowl Induction Hood.

 

The Air Box is finished from polish and back in.

 

Here are a few updated pictures of the progress. I will be running everything over for Powder Coat tomorrow and then will do the final installation. I still need to make the Switch Plate and run the rest of the lines. I also need to do all the wiring and install the NOS 3.5 LCD Launcher System.

Nitrous/Nano Rack





Solenoid Mounting/Relay/Purg Brackets

 

are you running the purg thru the floor? my buddy had to pull his bottle out b/c the purge was not up to spec.