A2A intercoolers; Bell complete IC vertical flow, Garrett core ready for fab
#1
Bell complete IC vertical flow, Garrett core - SOLD
Had the Bell on my supercharged TBSS many moons ago, has just been in storage. If someone would want that 90 elbow switched to straight outlet we could make that happen.
Bell core 22 x 8 x 3.5 see image for CFM flow, it should have no issue support upwards of 8-900hp or better. I figure if the small Procharger IC I have on the GTO supported 650whp and it’s core is smaller at 18 x 6 x 3.5 I’d say I may be conservative on the Bell rating.
$old
Brand new Garrett core, was going to build this instead of purchasing Prochargers 1300hp IC for the GTO (and F-body, same IC). Only difference is PC’s is 4.5” thick and this is 4”. Core size is 24” x 12” x 4” rated at a continuous 1000hp according to Garrett.
Going to stick some end tanks to this one.
Bell core 22 x 8 x 3.5 see image for CFM flow, it should have no issue support upwards of 8-900hp or better. I figure if the small Procharger IC I have on the GTO supported 650whp and it’s core is smaller at 18 x 6 x 3.5 I’d say I may be conservative on the Bell rating.
$old
Brand new Garrett core, was going to build this instead of purchasing Prochargers 1300hp IC for the GTO (and F-body, same IC). Only difference is PC’s is 4.5” thick and this is 4”. Core size is 24” x 12” x 4” rated at a continuous 1000hp according to Garrett.
Going to stick some end tanks to this one.
Last edited by ALL ULL C; 03-11-2022 at 04:16 PM.
Thread
Thread Starter
Forum
Replies
Last Post