the stock casting flow thread
Sep 4, 2007 | 10:14 PM
#13
The 241 castings will have a 2.00"/1.55" valve combination. The intake runner is 205cc and has a peak flow of about 240cfm@.500" lift. The exhaust runner has about 180cfm@.500" lift and I can't recall the runner volume off hand, but if you need it I'll get it in the morning. The chambers are going to be right at 67cc of volume.
Hope this helps.
Richard
Hope this helps.
Richard
Sep 5, 2007 | 06:44 AM
#14
Originally Posted by Richard@WCCH
The 241 castings will have a 2.00"/1.55" valve combination. The intake runner is 205cc and has a peak flow of about 240cfm@.500" lift. The exhaust runner has about 180cfm@.500" lift and I can't recall the runner volume off hand, but if you need it I'll get it in the morning. The chambers are going to be right at 67cc of volume.
Hope this helps.
Richard
Hope this helps.
Richard
That definitely helps, I left a message at the shop for you to either call or PM me, I havent heard back from you yet though, I'd like to talk it over with you. Thanks for your help
Sep 5, 2007 | 09:42 AM
#15
Originally Posted by silver-mod-o
That definitely helps, I left a message at the shop for you to either call or PM me, I havent heard back from you yet though, I'd like to talk it over with you. Thanks for your help
Richard
Sep 5, 2007 | 09:48 AM
#16
Originally Posted by Richard@WCCH
I tried your number in the afternoon yesterday and left a message on your voicemail. (I hope it was your voicemail). Try me again today.
Richard
Richard
cool, I'll try to give you a call after lunch my time (EST)
Thread
Thread Starter
Forum
Replies
Last Post
ARC
GMT 800 & Older GM General Discussion
57
Feb 21, 2022 10:54 AM
BIGD4504
GM Engine & Exhaust Performance
10
Jul 28, 2015 11:46 AM
sauldgold
GM Engine & Exhaust Performance
3
Jul 23, 2015 02:15 PM
GMCtrk
FORCED INDUCTION
67
Jul 17, 2015 06:39 PM