I have a Digital Designs 9512 sitting in my closet that I used in a previous ride. I was going to run two DD1508s under the back seat, but looking at the price, its very comparable to have my 9512 sent off and reconed to a 15. How does everyone feel about removing the 40 from the 60/40 rear seat and running a single 15? I know its not going to look the cleanest, but it will be super easy to pull out if I ever have the need to.

Plus, I really like the thought of a 9515 on about 3000 watts for daily.

 

No reason not to do it. It's your truck mod it however you like I'd do it not the cleanest look but it does the job and plays loud. hell I'm bed cutting my truck and doing 3 15's in it.

 

I can't do a bed cut. I use the bed of my truck for work way too often. I feel like a single DD9515 on about 3000 daily should be plenty. I remember when it was a 9512 in my reg cab... 2.5ft^3 @ 40 hz. KX2500.1 on it that benched 2880. Impossible to breathe. I'm not looking for quite that extreme this time, but 4ft^3 @ 35 sounds like a plan.

 

I've got a full blown work truck so this one is for moving myself and the family around. I bought the new one and with the justification of keeping the miles of my wifes 02 cherokee to her and take my truck on road trips long distance etc and leave hers at home. hehe

 

We did this in a CC f150 awhile back, it wasnt too bad of a look, different for sure, but not hideous.

 

 

Have any pictures? I've only seen one setup like this with something as big as a DD9515.