I figured you being where you are would want stainless, to keep it from rusting out... Being poor and all, figure it would cost less to do it once then buy cheap and have to do it again.... Kinda learned that with my tools years ago, can go to sears or harbor freight and buy the less expensive alternative or spend more for snap on and never have to buy it again because its under warranty and tends to last longer anyway!!!

 

Woops wrong thread for that video...will repost in correct thread

 

Let us know when the new batches are in. I'd like to run this on my 6.2.

 

I need this kit for my truck!!

 

So it's getting towards the end of July, any update on the new batch that'll clear a 6L80?

 

Last we heard we should be expecting them in around the first week of August. However, I read an email the other day that they might have sent us a prototype for the small elbow change we made for the 6 Speed Auto guys instead of a batch. I am hoping that's not the case. Still waiting for an update back.

Thanks
Sean

 

What's the latest Sean? I'm ready for an x pipe!

 

Nothin yet. I will let you guys know as soon as we hear anything.

Thanks
Sean

 

Well I'm so excited to buy this! Have the money for them but after see a revised edit on it I think it'll be better to wait? I like just bolting on and being done, than fabrications needed. If that's the case then I should just buy the mufflers or another kind and have a custom 3 inch dual with an x pipe in it. Also I like that there is a wideband bung already added but kinda hate were it is or even if I could get one in it. Is there a plan to fix that?

Let us know about the revised edit and if it'll work. If I'm wrong with my fitment let me know, 2001 Silverado extended cab 2wd, short bed, TSP headers.

 

Anybody have more dyno results?