Something's missing...
#15
Thread Starter
Wearin' da big hat
iTrader: (10)
Joined: Jan 2008
Posts: 10,262
Likes: 9
From: Over There
its a 5.3 with 16,000 miles on the clock. Not a bad motor to begin modding eh 
so far, it runs pretty damn strong after the cam swap. Definately needs to be retuned though. It is also about twice as loud as it used to be.
Just for a comparison of loudness. This new setup coming through the cutout is as loud or louder then when I ran open headers for an hour.

so far, it runs pretty damn strong after the cam swap. Definately needs to be retuned though. It is also about twice as loud as it used to be.
Just for a comparison of loudness. This new setup coming through the cutout is as loud or louder then when I ran open headers for an hour.
#16
U only ran open headers for an hour? Sissy.
I drove around for prolly a week w/ my 89 on open headers. That was due to tryin to find someone to do up a Y-pipe for my setup.
Loud as heck when I applied lots of pedal, but @ minimal pedal, it wasn't too bad. Had to watch for cops.
I drove around for prolly a week w/ my 89 on open headers. That was due to tryin to find someone to do up a Y-pipe for my setup.
Loud as heck when I applied lots of pedal, but @ minimal pedal, it wasn't too bad. Had to watch for cops.
Thread
Thread Starter
Forum
Replies
Last Post
Physh1
GMT 800 & Older GM General Discussion
6
Feb 25, 2015 05:58 PM



