GM Engine & Exhaust Performance EFI | GEN I/GEN II/GEN III/GEN IV Engines |Small Block | Big Block |

killing a dead horese

Old Jun 29, 2006 | 07:14 PM
  #11  
thunder550's Avatar
High on diesel fumes
iTrader: (70)
 
Joined: Mar 2005
Posts: 12,658
Likes: 3
From: Phoenix, AZ
Default

Over 100* (105-110) if I remember correctly. If I stayed into boost and let the AFR's run richer it seemed to lessen the severity.
Reply
Old Jun 29, 2006 | 07:24 PM
  #12  
jmproductions's Avatar
TECH Apprentice
 
Joined: Dec 2004
Posts: 393
Likes: 0
From: San Antonio
Default

There's really 2 issues creating the problem from what I can see. Modded, high performance engines create a lot more heat than stock engines (obviously) and also most electric fans will never be able to pull as much CFM as our stock clutch fans. I know some people may not agree with the latter but I would bet on it. This is not the first time I've heard of someone having to go back to the clutch fan. I know my efans are barely keeping things under control once ambient temps go over 100*.
Reply
Old Jun 29, 2006 | 07:46 PM
  #13  
TECH Resident
 
Joined: Mar 2005
Posts: 943
Likes: 0
From: Texas
Default

I know the new 1/2 ton trucks have e-fans but what about the 3/4 and 1 ton trucks?
Reply
Old Jun 30, 2006 | 12:53 AM
  #14  
CashDudeHomie's Avatar
TECH Addict
iTrader: (5)
 
Joined: Apr 2002
Posts: 2,911
Likes: 1
Default

I've got LS1 fans on a 5.3 radiator cooling my 6.0. Never any problems. Just put some thick foam around the fans starting about 4 inches from the bottom and go all the way around until 4 inches from the bottom of the other side. You can use thinner foam to fill in the rest but I just left it alone. This will give an almost air tight seal and also will lift the fans away from the radiator a bit. However if you are towing 6,000#, I don't know what to tell you. Sometimes when my mom's work car breaks down, I tow it back, but it only weighs probably 3800# or so.
Reply
Old Jun 30, 2006 | 01:06 AM
  #15  
thunder550's Avatar
High on diesel fumes
iTrader: (70)
 
Joined: Mar 2005
Posts: 12,658
Likes: 3
From: Phoenix, AZ
Default

Just to clarify...I never have problems driving around town, even in traffic, even when it's 115* out. I only run into trouble when I am towing, and only when it's uphill for awhile. It cools back off pretty friggin quick when I start downhill.
Reply
Old Jun 30, 2006 | 01:28 AM
  #16  
ltn's Avatar
ltn
Thread Starter
On The Tree
 
Joined: Jan 2006
Posts: 183
Likes: 0
From: Socal SD
Default

hey thunder on ur 05 e fans are they just like the ls1 connectors for the fans or are they something else. also did u use a nelson harness to make them work. thanks.
Reply
Old Jun 30, 2006 | 09:53 AM
  #17  
thunder550's Avatar
High on diesel fumes
iTrader: (70)
 
Joined: Mar 2005
Posts: 12,658
Likes: 3
From: Phoenix, AZ
Default

I have never seen an LS1 connector, but I think they are different. I used the Nelson harness, and I added my own manual switch to make the fans come on high with a switch I installed inside the truck.
Reply
Old Jun 30, 2006 | 10:13 AM
  #18  
ltn's Avatar
ltn
Thread Starter
On The Tree
 
Joined: Jan 2006
Posts: 183
Likes: 0
From: Socal SD
Default

o ic did u just get the harness and tap into the wires that came from the fans or what?
Reply
Old Jun 30, 2006 | 10:21 AM
  #19  
nonnieselman's Avatar
TECH Senior Member
iTrader: (10)
 
Joined: Oct 2004
Posts: 14,068
Likes: 2
From: Crystal Springs, MS
Default

Thunder, didnt you have a problem with over heating and it helped when you moved your Tranny coolers??
Reply
Old Jun 30, 2006 | 10:37 AM
  #20  
ltn's Avatar
ltn
Thread Starter
On The Tree
 
Joined: Jan 2006
Posts: 183
Likes: 0
From: Socal SD
Default

ok another question thunder, do u have power drains when ur fans kick on with the a/c because i was again reading up on the fans and people said that the 05 drain more power than the ls1 fans, is that true?
Reply

Thread Tools
Search this Thread

All times are GMT -5. The time now is 06:10 PM.