really the only thing I spotted on my set it the pipes at the flange the tubes are welded on the outside and all the other headers I have seen are all welded either on the inside or both sides. But they seem to be of good quality.

 

mine arrived today but havent had a chance to take a look

 

mine are commin friday. just need time and money to fab up a y pipe.

 

so when are yall going to install them? I hope to see if mine fit this weekend.

 

INSTALL THEM ALREADY!!!!!!!!! I already built true duals (with an x-pipe) over a years ago but have been waiting on headers because they cost too much. HURRY UP!!!!!

 

anyone else think there is gonna be a problem changin the back two plugs on the drivers side?

 

hey yall they WILL fit on a Z-71 and clears everything fine, I will post up some pictures in the morning but for now I am headed to be

 

no, now!!!!

 

dam it i just bought some pacesetters, i knew i should have waited

 

Well here are the pictures I took last night not the best angles but you get the point. There is a minimum of 3/4-1" of clearance around most everything. If you would like a pic of anything else just let me know and I will see what I can do.