Coil Pack relocation on a GMT800
#23
Truth be told the goal is not to see them. You can gain a little more room if I tore my insulation off the firewall and shortened the legs of the ICT brackets the coils are bunched together with. But it fits with the TVS in front so it's good for now. I will loom the wires out like a conventional small block. The ict brackets are bolted to a steel bracket that attaches to the back of the engine.
#24
I was found that leaving the coils in the stock location but flipping them upside down and using ICT billet 5’ wires was the best solution on my truck. Just didn’t have much room elsewhere
Thread
Thread Starter
Forum
Replies
Last Post
CashDudeHomie
GM Engine & Exhaust Performance
1
01-26-2006 04:47 AM