Building Blocks..................
Dec 2, 2008 | 08:48 PM
#21
Not nessacerly depending on your mods. You will have to have it tuned to maximize the economy.
As far as the Valve size goes Its not as much about the size of the valve as it is the voulme of area you have to fill. I highly recomend you do some more research in this area. A real good person to talk with is Richard at West Coast Cylinder heads. He is real knowledgeable In this subject with years of research to back it up...
As far as the Valve size goes Its not as much about the size of the valve as it is the voulme of area you have to fill. I highly recomend you do some more research in this area. A real good person to talk with is Richard at West Coast Cylinder heads. He is real knowledgeable In this subject with years of research to back it up...
Dec 3, 2008 | 04:07 PM
#22
Thread Starter
TECH Fanatic
iTrader: (1)
Joined: Mar 2007
Posts: 1,728
Likes: 29
From: Santa Fe New Mexico
Not nessacerly depending on your mods. You will have to have it tuned to maximize the economy.
As far as the Valve size goes Its not as much about the size of the valve as it is the voulme of area you have to fill. I highly recomend you do some more research in this area. A real good person to talk with is Richard at West Coast Cylinder heads. He is real knowledgeable In this subject with years of research to back it up...
As far as the Valve size goes Its not as much about the size of the valve as it is the voulme of area you have to fill. I highly recomend you do some more research in this area. A real good person to talk with is Richard at West Coast Cylinder heads. He is real knowledgeable In this subject with years of research to back it up...
Yeah- I'm arriving at 1.92" so far................
Thread
Thread Starter
Forum
Replies
Last Post
MA$TER_E
Tuning, Diagnostics, Electronics, and Wiring
5
Sep 9, 2015 03:14 PM
iregret
GM Drivetrain & Suspension
12
Sep 7, 2015 01:20 PM
