Boring a 5.3L Block
#1
TECH Apprentice
Thread Starter
Join Date: Apr 2002
Location: Honoulu, Hawaii
Posts: 369
Likes: 0
Received 0 Likes
on
0 Posts
Boring a 5.3L Block
Can a 5.3L cast-iron block be bored out to the same limits as a 6.0L cast-iron block? If not, what are the limits on the 5.3L?
#2
Adkoonerstrator
iTrader: (4)
Join Date: Nov 2001
Location: Deep in the seedy underworld of Koonerville
Posts: 21,436
Likes: 0
Received 3 Likes
on
2 Posts
Re: Boring a 5.3L Block
No to the 6.0L limits and check this thread for the rest of your question.
https://ls1tech.com/threads/showflat...=7&fpart=1
Did you try those plug wires yet? :p
John
https://ls1tech.com/threads/showflat...=7&fpart=1
Did you try those plug wires yet? :p
John
#3
TECH Apprentice
Thread Starter
Join Date: Apr 2002
Location: Honoulu, Hawaii
Posts: 369
Likes: 0
Received 0 Likes
on
0 Posts
Re: Boring a 5.3L Block
Tried them out. The Magencor LS1 wires I had seemed a little too short for my taste. Kind of felt that they were too tight and might lose contact. I stayed with the Magnacor 5.3L wires and just put on some wire connectors.
PS-thanks for the link. I've seen the thread before but just forgot about it.
Thanks,
Gregg
PS-thanks for the link. I've seen the thread before but just forgot about it.
Thanks,
Gregg
Thread
Thread Starter
Forum
Replies
Last Post
zblee
GM Engine & Exhaust Performance
3
11-11-2015 12:41 AM