This is my new meth injection plate. It flows 650ml.

 

Thats cool. Who makes it?

 

I'd like to know too.!

 

KRC Performance (www.krcperformance.com) had that made for me. They had a shop CNC machine the plate and then another local shop install the bars per my flow request. I asked for 650ml spray which took two bars.

 

Nice item. That's a lot of methanol.

 

I use the smt6 to drive my meth injection so it'll only run 650ml with full power to it. I manage the flow which isn't 650ml.

 

Very sweet! What was the asking price if you dont mind my asking?

 

Cost me $350. Can't say if it will remain that price but being the first and only person requesting it, it was made from ground zero. The hemi throttlebody doesn't have a sealed shaft. Anything going through can work it's way to the ETC motor. I think this is a good safety measure. I mean, we aren't even supposed to clean it. What do you think auxilary fuel, meth, or even nitrous can do to the ETC....?

 

How big are those small holes in the cross tubes?
I could machine one of those up for me at the TB.