Has anyone had problems with the sensor not reading right? Trying to tune my truck but the most kpas I can get out of it is 155ish. Not sure if the sensor is off or my gauge. My gauge is showing like 18lbs. No matter where I adjusted my boost controller the kpas stay the same. Could my controller be going bad? Or dis the sensor seem more logical

 

Well if im not mistaken a 2 bar sensor is only good to 15 psi so that might be a problem

 

I'm not sure if it was the way I was logging it or what. But I got it to read correctly now. Still under 15lbs. Is around 196ish kpas

 

You have to go into your HPTuner tables and get rid of the map(sae) pid and add the 2bar map pid. (right click>insert)

is that the part that you missed? Also, is the KPA offset set properly in the tune?