Guys checking to see if anyone has any info on these slicks. Like pressure and does this slick like big burnout or a short burn out. Please help

 

18 to 20 psi
Small burn out

 

Is that air pressure hot or cold?

 

Cold

Lower makes them hook worse and best to use them on least 9" wheel

 

Mine worked better at 16psi or so.

 

These Hoosiers slicks are new to me also slicks on a 5800lb truck too.

 

Honestly not enough footprint for your truck unless 4wd and have good boost controller

 

with my slicks, i always did a burnout like this

roll through water box
get them spinning in 1st, right into 2nd. hold rpm around 4500
hold until whitish smoke
roll out a car length and ease off throttle

i would think 15-16 psi. test and tune my friend.

At my local track I could get 8-10 passes no prob. make 2 at 17psi, then 2 at 16, then 2 at 15. keep burnouts and launch rpm the same. Compare slips

 

When I ran less then 18 my 60 lost..went into the 1.7s

 

I was doing 1.8's and a best 1.81 on NT05R street tires. So I think 1.7s should be easy. I have a ams 500 boost controller with CO2 and 2wd with Caltrac's