wire loom relocate
#1
TECH Regular
Thread Starter
wire loom relocate
Anyone have any ideas on how to relocate my wire loom? It lays on top of my ls3 intake and is rubbing it badly. I need it moved around the back of the engine or somethingv
#4
TECH Regular
Thread Starter
I figured I would have to undo it. May make it worth my while and pull out the stuff not used as well. Well I appreciate the suggestions! I may PM y'all if you don't mind when I do it.
Trending Topics
#8
TECH Regular
Thread Starter
The stuff i would remove while i had it out would be evap, trailer wiring, rear o2, i could remove oil pressure since i am running a mechanical gauge, AC my A/C leaks and never holds freon so gave up on it.
JHForeman your setup looks clean and easy to work on with all the wiring cleared.
JHForeman your setup looks clean and easy to work on with all the wiring cleared.
#9
TECH Regular
Thread Starter
#10
I couldn't handle the clutter that our truck engine bays have!! I separated the whole harness pulled the o2 sensor wires out(I knew I would be using them), ran all the wires the way I wanted, and crimped new terminals on. I also relocated the coil packs while I was at it, elimintated the stupid coolant tank and so fourth. I still have ac/heat.