Still having problems!
Mar 24, 2009 | 05:04 PM
#1
Thread Starter
Staging Lane
Joined: Aug 2007
Posts: 56
Likes: 1
Still having problems!
I was getting P0171 and P0174 right and left lean codes. I replaced the MAF sensor and took care of that problem now the computer is kicking out P0108 (MAP sensor voltage too high). Can anyone out there help. I don't know why but these 2 problems will not let the truck start and run. It has started but only for a few seconds and, the MAP sensor has been replaced.
Last edited by 600 horses; Mar 24, 2009 at 07:22 PM.
Mar 25, 2009 | 03:28 PM
#4
Thread Starter
Staging Lane
Joined: Aug 2007
Posts: 56
Likes: 1
I have a cold air and open exhaust with factory cats, and a hypertech programmer. The programmer has been sent back because it was giving an error code, but I was informed that it should have nothing to do with what is going on now. I'm thinking that they may be wrong!
Thread
Thread Starter
Forum
Replies
Last Post
2002_Z28_Six_Speed
GM Drivetrain & Suspension
17
Oct 4, 2015 01:34 PM
