When doing some WOT runs, the scanner was only showing 84% TPS. Is this normal?

Also, when looking at the PE Enable table, the values were all set to 87%. So does this mean my truck was never entering PE considering the 84% vs. 87%?

 

There's a different TPS pid that you need to moniter. I can't recall the actual name of it right now, but I know it's been discussed quite a few times here, and on the HPT board as well. I can look it up for you tomorrow if you need me to.

 

HP Tuners Bulletin Board - View Single Post - 2005 A4 GTO Help please.

 

Thanks Charlie. Saved me from searching!

 

LOL I see this question all the time

 

I see it alot too, but it's been a while.

 

Thanks. It's all Greek, but it seems like even though it's reading 84%, the tune is still seeing 100%, therefore it is entering PE?

 

Aha, good to know!