Oh ya i forgot i used those tbolt clamps instead of the worm gear one. Those tbolt clamps are awesome, i will never is worm gear clamps again.

 

Did you screen the new MAF? If so, what's the reason? I've ran a card-style for going on two years with no screen and encountered no problems.

It looks nice finished, though. Do you have any numbers as far as intake temp goes? How much worse is the heat soak?

 

Nice write up and good info, should be considered as a sticky for future reference.

 

Nice, Hows it running? Where did you pick up the AMD 100mm MAF housing? Cant seem to find them.

 

It is running good! It is alot smoother than running SD. Goto yahoo and type ADM MAF. I bought it from a nonsponsor.

 

Very nice write up... I'm curious as to the reasoning behind the post-maf air screen... I wouldn't think it would affect the airflow ahead of it but I am probably wrong. I really like the iat sensor you used, makes it nice not to have to weld on a bung. Do you think the sensor fits tight enough in the grommet to prevent a leak on a boosted setup? Also, is this the same sensor that is used on the NNBS trucks? I was under the impression that they were an improvement over the older style maf's as far as maxing the sensor

 

Best Handmade I've seen to date . Great job ..