So what your next projects on your truck
Nov 7, 2013 | 11:58 PM
#31
I just recently had a 91+ tune from BB installed via my Autocal. I'd like to see what my truck does in the 1/8 with it's current mods before doing anything else.
Next would be getting the long tube headers, y pipe, and corvette servo installed as well as an updated tune to account for those mods. Then another trip to the track to see where she stands after all of the above.
Next would be getting the long tube headers, y pipe, and corvette servo installed as well as an updated tune to account for those mods. Then another trip to the track to see where she stands after all of the above.
Nov 8, 2013 | 03:13 AM
#33
Finish my setup going on now, since my last motor blew (spun bearing and torched motor). Currently going on and finishing:
1. 4l80e swap from 4l65e, waiting on kit from dana and will be installing right after
2. bought new forged short block and finisihing assembly, degree cam and motor will be done.
3. Mock up turbo setup but noticing it takes alot of damn time, and might ask someone to do it for me. I have all the pipe sitting in my garage and no time to do it. I currently had mid-mount and threw it all away and now going front mount.
4. New fuel system needs put in (walbro 450)
5. Need injectors but not sure what style etc to buy. I just know I want 83lb's inj's, haha
6. Waiting on turbo blanket
7. Waiting on input shaft from Time2kill, just finished that and need to put back in case.
8. Considering selling my current turbonetics 7675 ball bearing turbo, depends if someone gives me enough for it.
9. Need to add dual nozzle meth, but need to look for an extra solenoid and nozzle.
10. Need segment swap but I believe I know someone that can do it
11. Tune truck and break it all in, and get ready for track days.
Damn, that is alot, holy crap I need help.
1. 4l80e swap from 4l65e, waiting on kit from dana and will be installing right after
2. bought new forged short block and finisihing assembly, degree cam and motor will be done.
3. Mock up turbo setup but noticing it takes alot of damn time, and might ask someone to do it for me. I have all the pipe sitting in my garage and no time to do it. I currently had mid-mount and threw it all away and now going front mount.
4. New fuel system needs put in (walbro 450)
5. Need injectors but not sure what style etc to buy. I just know I want 83lb's inj's, haha
6. Waiting on turbo blanket
7. Waiting on input shaft from Time2kill, just finished that and need to put back in case.
8. Considering selling my current turbonetics 7675 ball bearing turbo, depends if someone gives me enough for it.
9. Need to add dual nozzle meth, but need to look for an extra solenoid and nozzle.
10. Need segment swap but I believe I know someone that can do it
11. Tune truck and break it all in, and get ready for track days.
Damn, that is alot, holy crap I need help.
Nov 10, 2013 | 04:18 PM
#36
Well after test and tune today, my next project is going to be replacing the knock sensors and sub harness. Pretty sad when you gain 40hp via cam swap and milled heads, but run a full second and 5 mph slower then your times before the work was done.
Nov 10, 2013 | 04:29 PM
#37
