Look at the BS ive had to go threw the last 24hrs
#92
Thread Starter
12 Second Truck Club
iTrader: (18)
Joined: Aug 2008
Posts: 1,107
Likes: 0
From: Cypress, TX
little update....as all of u know about the BS i have gone through with the iron ls1 I bought, i said screw it and jumped back on the aluminum ls1 i had. i had bought it back in march, it needed new cam bearings b/c they were not installed correctly, and one was too far back blocking the oil passage. at the time i didn't know the whole rotating assembly had to come out to do that. That was the reason i bought the iron one, so i wouldnt have to mess with it..... Anyhow, tore it down, had new Durabond cam bearings installed. I then went to Polydyn, there are here locally in Houston, and bought a set of clevite77 H series main and rod bearings with the Polydyn coating on them. Installed the crank, had a buddy( montecarloss) install the rods and pistons and arp rod bolts for me. And tonite i just ordered a set of arp head bolts, head gaskets, melling 10295 oil pump, and my Cam. Im going with the TSP torquer v2---232/234 595/598 112. should run good. Im putting my 706s on it for now, that should be right around 10.9 cr with those heads. im shooting for memorial wknd to do the swap!!
#95
#98
#100
Thread Starter
12 Second Truck Club
iTrader: (18)
Joined: Aug 2008
Posts: 1,107
Likes: 0
From: Cypress, TX
The little bitch fell off the face of the earth. Sherriff called him to speak with him, and he hung up on them. he moved out of his parents house, changed phone #. bobbin and weavin so he wont get caught. Sherriff nees a new addy so they can try and serve him. Ive chalked it up as a loss, and a valuable lesson learned. The white trash mother f*cker obviously needs the money more than me. Life goes on, he will get his one day, karma is a ****!!!




