Ask black bear to email you a pid list file

 

He did but he forgot to include thr wideband. He told me to just add it and I figured it was within my skill set.... Not looking like it now lol.

 

That creeper looks like it would be uncomfortable as hell, and would make reaching anything remotely near the bottom of the engine(i.e. The bolt for the harness that runs across the front of the oil pan and the two front oil pan bolts) a bigger pain than just hanging off the front of the truck...


This is what i have, usually end up with a bungee cord wrapped through it but it works!!!

 

I will stick to the wrench and leave the tune to the pros,to much at stake,tuning is cheap in the big scheme of things.
I would get started without wide band until the end,Is he asking for wide band log right up front? the wide band should only be like one Pid?

 

Ok I worked around it. I went into the SAE_generic file and found the preprogrammed wideband and just changed one of them to match the scaling of my aem. I just went out and logged it and everything is fine.

Justin wants me to go in boost but not tach up too high. Much easier said than done. It just wants to break the tires free under boost even at low rpms, then it tachs up to quick. I might try 4x4 launches to keep traction and be in boost, but not go high rpm.

 

Hell yea!

 

Hell yeah....WOOF!