Shaved the rear end....
05-14-2007, 11:52 PM
#1
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Oct 2005
Location: Fresno, Ca
Posts: 1,066
Likes: 0
Received 0 Likes
on
0 Posts
Shaved the rear end....
decided that the bumper needed to go......
its a bolt in, but i did alot of body work to make sure that it fit the right way.
its a bolt in, but i did alot of body work to make sure that it fit the right way.
05-15-2007, 12:05 AM
#3
TECH Enthusiast
iTrader: (1)
Join Date: Apr 2006
Location: Fredericksburg, Va
Posts: 593
Likes: 0
Received 0 Likes
on
0 Posts
lookin good, prolly bent the outer tabs a bit and to flush out the seams w/ the q-panels and if you did the prep work, sir mikes gotta be smoothed and filled around the license box.
05-15-2007, 12:09 AM
#4
TECH Fanatic
Thread Starter
iTrader: (8)
Join Date: Oct 2005
Location: Fresno, Ca
Posts: 1,066
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by 8MC
Looks real good. What do you mean by a lot of body work?
the curve wasnt quite right on the pan, around the license plate was a little bit low....
under the pan at the endpoints needed to be bent a little bit. both sides needed to be cut at angles to fit the truck bed. each truck is a little bit different so nothing is going to line up perfectly.
Originally Posted by RedHot04
lookin good, prolly bent the outer tabs a bit and to flush out the seams w/ the q-panels and if you did the prep work, sir mikes gotta be smoothed and filled around the license box.
exactly...
Trending Topics
05-15-2007, 08:21 AM
#8
, very sweet looking truck bud, what did you do with the old bumper?
