So it's hard to get good pictures since the truck is lowered, but here are some tranny, driveshaft, and exhaust pictures. The welds look really nice on the exhaust




5" driveshaft with 1350 solid u-joints




Pretty much a straight shot back from the downpipe. There's a slip fit clamp and then a 3" to 4" expansion




30" long magnaflow muffler. Sounds really good and is mostly quiet in the cab except a few RPMs, but most of that is probably the solid engine mounts.




The crossover hangs down pretty low, may have to get that raised up one day

 

 

Not yet, I haven't put them on yet. I need to wash the truck then swap wheels. I also don't have a professional alignment yet so I would like to do that first before I put my expensive tires on. I also need to roll my rear fenders because they hit the tire on big bumps right now.

 

Washed the truck to get ready for a car show this weekend. Trying to decide whether to polish it or just wax it and go. Still need to get an alignment and swap wheels, then detail the brakes and engine bay

 

you going to Bastrop car show?

 

Yes, weather permitting I'll be there

 

Put the new wheels and tires on after work. Really changes the look of the truck, but I will say pictures don't do it justice. Looks sharp

 

 

Beautiful job and great choice of wheels.

 

Who did your exhaust? Beautiful truck!!!!