Can't stay stock!
Jul 17, 2011 | 03:53 PM
#31
I am going to align the truck soon.
I was planning to have it aligned to have a touch of toe and negative camber put in before the drop plans. The drop did both and only a tiny bit but I am going to have my alignment tech make sure it isn't too much some time this week.
I was planning to have it aligned to have a touch of toe and negative camber put in before the drop plans. The drop did both and only a tiny bit but I am going to have my alignment tech make sure it isn't too much some time this week.
This should get good, the hounds have been released, 
Jul 18, 2011 | 07:41 PM
#37
Holy ******* ****!!! At first I snickered...
The TB is being shortened for one of the cups. The guy who was supposed to cut my throttle blade has been imposible to get ahold of so I quit calling. I had another section of the pipe but it wasn't long enough to get the two 3" sections I needed.
In the future I may give the TB another go, but, since I will have to buy supplies, I will probably just but a TB.
In the future I may give the TB another go, but, since I will have to buy supplies, I will probably just but a TB.
Jul 18, 2011 | 07:59 PM
#39
Hey fellas, Looks like he's got this under control LOL....
Like I said, I'm gonna try to just sit back and observe on this one. I'm hoping for his family's sake (since I am guessing they will be the ones in the SUV) that he'll scrap this project like the doomed TB
Like I said, I'm gonna try to just sit back and observe on this one. I'm hoping for his family's sake (since I am guessing they will be the ones in the SUV) that he'll scrap this project like the doomed TB
Jul 18, 2011 | 08:05 PM
#40
Exactley, im all for modding man, But this again doesnt look too safe IMO