Been registered for a while, 2500HD CCLB checking in.
May 29, 2012 | 07:10 PM
#1
Thread Starter
Teching In
Joined: Feb 2007
Posts: 8
Likes: 0
From: Indianapolis
Been registered for a while, 2500HD CCLB checking in.
I've been registered on LS1Tech for a while, but never really posted. I finally made it over here though.
I drive a 2002 GMC Sierra 2500HD SLE 6.0 4wd Crew Cab Long Bed. It has a handful of mods, but not a whole lot that is noteworthy. I retrofitted the headlights, as you can see down below. The stock muffler has been replaced with a Coast Fab bullet off of a Grand-Am car (it was free, and doesn't sound too bad). I also added LED courtesy lights for the rear footwells, a second battery, 250a alternator, e-fans, 2" blocks and raised the t-bars, and also NBS Silverado tail lights. I'm sure there's more, but obviously it's not important if I can't remember it.
I'm looking to get a BB tune and might eventually do a cam, LTs, and TBSS manifold. I'd also really like to get a Silverado HD hood on it, as well as a Z71 valance with round fogs. Once I get my welder set up (and find the time) I'm going to put some helper bags on it, as well as on board air and train horns.
I have so many projects to do, and so little time left in the day.
Here's the truck the day after I got back home, driving it to Indianapolis from the East side of Pennsylvania.
The most recent side shot.
The most recent picture, showing the tow mirrors and Denali lights retrofitted with Morimoto H1 HIDs.
I drive a 2002 GMC Sierra 2500HD SLE 6.0 4wd Crew Cab Long Bed. It has a handful of mods, but not a whole lot that is noteworthy. I retrofitted the headlights, as you can see down below. The stock muffler has been replaced with a Coast Fab bullet off of a Grand-Am car (it was free, and doesn't sound too bad). I also added LED courtesy lights for the rear footwells, a second battery, 250a alternator, e-fans, 2" blocks and raised the t-bars, and also NBS Silverado tail lights. I'm sure there's more, but obviously it's not important if I can't remember it.
I'm looking to get a BB tune and might eventually do a cam, LTs, and TBSS manifold. I'd also really like to get a Silverado HD hood on it, as well as a Z71 valance with round fogs. Once I get my welder set up (and find the time) I'm going to put some helper bags on it, as well as on board air and train horns.
I have so many projects to do, and so little time left in the day.
Here's the truck the day after I got back home, driving it to Indianapolis from the East side of Pennsylvania.
The most recent side shot.
The most recent picture, showing the tow mirrors and Denali lights retrofitted with Morimoto H1 HIDs.
Thread
Thread Starter
Forum
Replies
Last Post
Stainless Works
TrailBlazer SS
6
Apr 10, 2016 04:34 PM
