422 LSX and some other goodies at dad's shop :D
Jun 29, 2011 | 09:32 PM
#12
Hmmm, good thought Corey, actually, I don't even know what oil pump he is going with, I'm going to have to ask him about that next time I swing by his shop Just a thought i have no real experience..
Jun 29, 2011 | 09:47 PM
#13
Thread Starter
PT's Slowest Truck
iTrader: (19)
Joined: Apr 2004
Posts: 17,863
Likes: 2
From: Hackensack, NJ
I'd be smiling if that were my mill for sure! 
Yea I'm familiar with the 1/2" holes in the lifter tray trick (saw it in Will Handzel's book 
), not sure if my pop is or not though...I may have to run that past him 
Originally Posted by BlackGMC
Ya because if the guy is going to actually race it around the track it may be needed. Also he should probably drill the lifter trays, that extended high rpm running will cause the oil to pool up in the lifter trays.. The guys on tech recommend drilling them if your going to be at high rpms for an extended amount of time.
Just a thought i have no real experience..
Just a thought i have no real experience..
), not sure if my pop is or not though...I may have to run that past him
I'll try and get some pics of the actual shop and some of the cool machines next time that I'm over there too 
Jun 30, 2011 | 08:30 AM
#16
I seriously doubt he will use trays with a solid roller setup. More then likely a link-bar lifter.
Thread
Thread Starter
Forum
Replies
Last Post
someotherguy
STEREO & ELECTRONICS
10
Oct 5, 2015 12:49 PM
blown02408
GM Engine & Exhaust Performance
8
Oct 1, 2015 01:06 AM
