Anyone still running a PVC 4in intake setup?
Nov 10, 2012 | 09:27 PM
#42
Here ya go: 
Im having an issue with the pipe rubbing the idler pulley though, think I may be able to solve it by running a bead of silicon around inside the elbow and pulling the tube in tight to hold it. Input on how anyone else solved this is very welcome haha.
Im having an issue with the pipe rubbing the idler pulley though, think I may be able to solve it by running a bead of silicon around inside the elbow and pulling the tube in tight to hold it. Input on how anyone else solved this is very welcome haha.
Sep 13, 2014 | 11:26 PM
#44
siliconeintakes dot com. I tried the hardware store stuff but it didn't work out, so I bit the bullet and ordered stuff. $65 shipped and that was everything but the tube, which was about $3 from hardware store. Only problem was 2 of my hose clamps were too small 
I used 4"-4" elbow, 4"-3.75" reducer, 10mm vacuum hose, 1/4"NPT x 3/8th barbed brass fitting, couple .5" clamps, one 3.75" clamp, one 4" clamp and need two more 4.5" clamps.
I used 4"-4" elbow, 4"-3.75" reducer, 10mm vacuum hose, 1/4"NPT x 3/8th barbed brass fitting, couple .5" clamps, one 3.75" clamp, one 4" clamp and need two more 4.5" clamps.
Thread
Thread Starter
Forum
Replies
Last Post
lxcoupe
FORCED INDUCTION
8
Jul 21, 2015 02:12 AM
