Just curious, I'm considering some front Recaro buckets but not sure how to integrate the seat belt without welding in a roll bar.

Pics, if you got em, post em, thanks

 

wow, nobody?

 

I'm curious too. I did some looking a few months ago but it seems that high performance seats aren't a priority for us truck guys.

 

Once I break into the 11's ... I will be looking for some seats. I saw some on the Jegs wesite that APC made for trucks. They looked nice but I don't think they were race approved.

 

my thought has always been to use an old-school GM seatbelt that mounted to the floor and ran up the back and through a slot in the seat (Kinda like the old Regals and Delta 88's had)...that would allow us to use ANY seat that had an opening for a 5-point harness

 

Yelo brings up a good point .... I think another eason no one has gone to a new seat is because the seatbelt is on the seat.

 

I have to agree with that too.

 

i want to try and get these:
http://www.stylinconcepts.com/part.c...D=1&lc=pfpartt

 

That's what I saw on the Kegs site, but it was about 200 less. You would have to get a harness with them though.

 

If someone was determined to modify a stock seat to take a 5 or 6 point harness, would that be considered legal to run?