this converter was $1000new. the lock up clutch needs relined and then welded back together and balanced. yank estimated repairs cost at $200.



the converter worked prety good. i pulled a low 1.6 with it in my heavy truck and a best of 10.91 in the 1/4. just seems that a single disk converter is not ideal for what i am trying to do.

here is what yank says about their py3400e converters.

"Pro Yank Series Converters:

Power adders place special demands on converters. It is important for a converter to have adequate "holding power" while at the same time, placing the motor in a higher power band through increased stall. The Pro Yank converters give you the best of both! First, each Pro Yank is custom built around "your" power adder. The stall speeds are rated for use with power adders and will therefore, be right where you need it to be. Next, the Posi lock-up clutch will bring efficiency close to 100% by locking-up under load. Finally, the clutch materials are built to take the higher demands of running on the "juice". The Pro Yank Extremes use the exotic Kevlar linings."

 

Very interested, please let me know if this is still available, Thanks Dave

 

Sold!!

 

what he said!!