Procharger Custom 4" Air Intake System
#1
TECH Resident
Thread Starter
iTrader: (36)
Join Date: Dec 2006
Location: Lafayette, CA
Posts: 990
Likes: 0
Received 0 Likes
on
0 Posts
Procharger Custom 4" Air Intake System
I sold my Procharger system so I no longer need this custome intake set-up. This system is made off 4" aluminum and steel piping, extra heavy duty exhaust wrap to keep out the heat and rubber elbows. Most of the piping is 4" round aluminum but the piece over the intake is 4" steel and slightly "ovaled" for hood clearance. It has a port at the head unit for the bypass valve tubing (just like a stock P-1SC Air filter) and another port to hookup the pcv tubing right at above the intake manifold. With this system, I maintained AIT's at about 3-7 degrees above ambient, even after a full pass. I lost about a 1/2 pound of boost with this system over the original P-1SC air filter but it also really quieted down the air intake noise.
I spent about $250 on all the pieces to build it so I would like to get $125 plus shipping. I am located in the San Francisico Bay Area.
Thanks, Rick
I spent about $250 on all the pieces to build it so I would like to get $125 plus shipping. I am located in the San Francisico Bay Area.
Thanks, Rick
Thread
Thread Starter
Forum
Replies
Last Post
Suburban2500
GMT 800 & Older GM General Discussion
2
07-14-2015 02:10 AM